2N IP Uni, Руководство по установке

Страница: 26 / 58

Installation manual 2N® IP Uni
26 / 58
•
•
•
1.
2.
3.
4.
5.
6.
Flush Mounting – Classic Bricks
(including hollow bricks, thermally insulated
walls, etc.)
What you need :
A properly cut hole
Plaster, mounting glue, mounting foam or
mortar as necessary
Cut a wall hole using the template enclosed. Make
sure that all the required cables are available in the
hole.
Unpack the plastic mounting box. Break out the cable
holes as necessary and make sure that the wall hole is
big enough for the box.
Wall up the mounting box making sure that the box is
aligned with the wall surface. Wait until the plaster
(mortar, mounting foam, etc.) sets.
Unscrew the front panel from the door intercom.
Connect the cables to the terminals or RJ connector as
described in the Electric Connection subsection.
You can use the cable tie for connection as shown:
•
•
•
Caution
Before starting the mechanical installation on a selected place, make sure
carefully that the preparations connected with it (drilling, wall cutting) cannot
damage the electrical, gas, water and other existing wires and pipes.
The warranty does not apply to the product defects and failures arisen as a result
of improper mounting (in contradiction herewith). The manufacturer is neither
liable for damage caused by theft within an area that is accessible after the
attached electric lock is switched. The product is not designed as a burglar
protection device except when used in combination with a standard lock, which
has the security function.
When the proper mounting instructions are not met, water might get in and
destroy the electronics. It is because the intercom circuits are under continuous
voltage and water infiltration causes an electro-chemical reaction. The
manufacturer's warranty shall be void for products damaged in this way!
