2N IP Solo, Руководство по установке

Страница: 45 / 66

2N TELEKOMUNIKACE a.s., www.2n.cz 45/66
Configuration:
Connect the to the properly set intercom switch 2N Helios IP Security Relay
®
output; refer to the . Make sure that one LED 2N Helios IP Configuration Manual
at least on the is on or blinking. 2N Helios IP Security Relay
®
Press and hold the Reset button for 5 seconds to 2N Helios IP Security Relay
®
put the device in the programming mode (both the red and green LEDs are
blinking).
Activate the intercom switch using the keypad, telephone, etc. The first code
sent from the intercom will be stored in the memory and considered valid. After
code initialisation, the will pass into the operational 2N Helios IP Security Relay
®
mode (the green LED is blinking).
Caution
In case of resetting the factory default settings on a device with a
version of firmware 2.18 or higher it is necessary to reprogram the
using the instructions above. 2N Helios IP Security Relay
®
Tip
FAQ: 2N Helios IP Security Relay – what is it and how to use it with 2N
®
Helios IP intercom?
Tip
Video Tutorial: Door intercoms 2N Helios IP Security Relay
®