2N Helios Vario, Руководство по установке

Страница: 39 / 74

39
2N TELEKOMUNIKACE a.s., www.2n.cz
®
3.1 Programming
All parameters, including the keypad ones, are set remotely using any 2N Helios
®
tone-dialling telephone set (or a mobile phone). First call and enter the 2N Helios
®
programming mode. The access to this mode is service password protected.
A voice menu is available in the programming mode and so you need not use this
manual to program standard parameters. The menu is stored in the
memo 2N Helios
®
ry in the default language. Having entered the full parameter or memory number, you
can hear how the parameter has been programmed, thus checking the programmed
numbers for correctness.
All parameters are stored safely in the non-volatile EEPROM memory. The memory
capacity does not limit the count or length of numbers, passwords, etc. This means
that altogether 324 memories for 16-digit telephone numbers, 54 Arrival/Departure
password memories, 20 switch password memories, etc. are available.
Entering Programming Mode
You can enter the programming mode only during an call (telephone – incoming 2N
®
call). The programming barring jumper must not be mounted. To get into the Helios
programming mode, enter the in the format (do service password password
not forget to enter the asterisks before and behind the password!). The service
password is 12345 by default and can be changed ,. If you enter the password
correctly, the voice menu is launched. Now you can start programming.
Programming Procedure
You can set parameters in any order and as many times as you wish. To change a
parameter use the following command:
Parameter number parameter value
A three-digit is assigned to every parameter to be programmed parameter number
and to every memory (refer to the Programming Chart). This number indicates to 2N
®
which parameter to change, and is used as "Enter". When it is entered, Helios 2N
repeats the parameter (or memory) number and reads the current contents Helios
®
(excluding passwords). Now you can enter new data – of variable meaning and length
depending on the parameter selected (refer to the Full Parameter Chart). Finally, press
Tip
Write or print the values to be programmed to minimise the risk of error.
Moreover, this gives you an idea of what you have programmed. Make
sure that programming is not barred (JP1 jumper) – refer to the PCB
Description subsection