2N ATEUS 501101E, Руководство пользователя

Страница: 37 / 57

35
Notes to Basic Parameters:
•
Parameters connected with SIM-card protection
The “PIN“ parameter is used only if “Enter Automatically” is selected and the SIM card
requires the PIN. If you enable the SIM-card function without PIN entering, you will not need
this parameter. If “Enter Automatically” is selected and you do not enter the PIN, enter a
wrong PIN, or replace the SIM card without entering the new PIN, the GSM Gateway will try
to enter the old PIN once, identify its invalidity, and invite you, if you try to dial, to enter the
PIN manually (by PIN tone
). If you enter the new PIN correctly, it will be
saved without programming. If you select the “Enter PIN Manually” mode, you will have to
enter the PIN upon every power-on and the GSM Gateway will not store it anywhere.
•
Parameters connected with GSM network
CLIR (number of the calling extension, i.e. of your GSM Gateway) is normally sent to the
called party. The “Incognito” option should be applied for with your GSM operator (usually
for a single fee).
WARNING!!! If you have not activated this service with your GSM operator
and set the “Incognito” function at 1 = Do Not Send Number, no outgoing calls will be
established in some GSM networks!!!
There is a risk with roaming in frontier areas that, due to a failure in your native GSM
network, the GSM Gateway might get registered in a GSM network of the neighbouring
country and all GSM calls will be much more expensive. If you enable roaming, you should
set your SIM card properly and activate the service with your operator! If you disable
roaming here, it is an unambiguous barring command that depends on nothing else.
Incoming call enable: The GSM Gateway is designed for outgoing calls primarily, because
you mostly do not pay for incoming calls and thus cannot cut your telephone costs. If, however,
incoming calls occupy the GSM Gateway for a considerable period of time, this might make
your outgoing calls more difficult and diminish the expected cost cuts. Should your GSM
Gateway be too busy, you are advised to bar incoming calls. To cut incoming call costs too
(from employees moving outside the company, e.g.), you can install another GSM Gateway for
incoming calls only using a SIM card with pre-paid services (no monthly lump sum will be paid).
•
Silence after dialing
During an outgoing call, GSM gateway with TC35 engine sends a "connecting tone" after
dialing. This is similar to common mobile phones. Starting with software version 2.35, a new
parameter 111 can be used to silence this connecting tone.
•
Target applications :
Connecting tone can cause a wrong functioning of some special devices, which
evaluates call progress tones - e.g. some call centers and like. Also some users prefers
to hear ringing tone only, as well as in case of common PSTN call.
•
Important note :
Default value of this parameter is zero. To mute connecting tone, set a silence time,
e.g. 10 sec.
•
Parameters for dialling supervision and intelligent incoming call routing
Dialling end identification: If the GSM Gateway does not identify the end of the dialled
number by any faster method (refer to the Call Sorting table), it waits for a pre-set timeout. Then
(or immediately if it identifies the dialling end by a faster method), it sends a short beep, whose
length can be adjusted, and starts establishing the connection with the called party.