Z-Wave Wall Controller SR-ZV9002T4-CCT-RU
Product Data
Z-Wave Frequency
Power Supply
Power Consumption
Operating temperature
Relative humidity
869.0 MHz (RU)
100-240VAC, 50/60Hz
< 0.5W
0 to 40°C
8% to 80%
Safety & Warnings
•
•
DO NOT expose the device to moisture.
Quick Start
How to install:
•
Step 1: turn on your wall controller.
•
Step 2: activate inclusion mode on your Z-Wave controller.
•
Step 3: activate inclusion mode of your wall controller by pressing the
“inclusion/exclusion” button or long press “ALL ON/OFF” button over 3 seconds.
Product Description
The Wall controller is a Security Enabled Z-Wave Plus device that can both control other
Z-Wave devices and activate scenes in Gateways. The wall controller can be included
and operated in any Z-Wave network with other Z-Wave certified devices from other
manufacturers and/or other applications. All non
‐
battery operated nodes within the
network will act as repeaters regardless of vendor to increase reliability of the network.
Although it is controlling other devices, the device cannot act as Z-Wave network
controller (primary or secondary), so a security enabled controller is needed for take full
advantage of all functionally for the device. It also supports the Over The Air (OTA)
feature for the product’s firmware upgrade.
The wall controller has following functions:
1. Control of groups of other Z-Wave devices using 'ON', 'OFF', Dim and Color Control
commands.
2. Activation of scenes in Gateways.
The encryption modes that the wall controller supports are S0, S2 Unauthenticated.
When the wall controller is being included into a Z-Wave network, you can use your
primary controller/gateway to enable one encryption mode or disable encryption. (The
primary controller/gateway shall support encryption mode configuration).
DO NOT install with power applied to device.
