05/29/2018
1/2E
If light doesn’t turn on, check the
battery to ensure that it is making
secure contact with the terminals.
If this doesn’t work, replace with a
new battery.
Tools Required
Screwdriver
Pencil
Electric drill
drill bit size:
ø7.5mm (3/10 in.)
Mark the location where you want to mount the light.
Drill two holes.
1
Marking the location
Measure the width of two holes on the back of the solar fence
light to align holes for 2 the screws (A) on the surface. The
distance between the two holes is 96mm.
2
Fixing the screws
Insert the screws (A) and leave at least 1/4 in., or 5 mm of the
screws (A) outside of the surface for holding the solar fence light.
Insert the plastic plugs (B) so they are flush with the surface.
REPLACING THE BATTERY
TROUBLE SHOOTING
FOR FIRST TIME USE: SOLAR LIGHT NEEDS TO CHARGE IN FULL SUNLIGHT FOR 8 -12 HOURS WITH THE SWITCH IN
THE “ON” POSITION TO ALLOW THE RECHARGEABLE BATTERIES TO REACH MAXIMUM CAPACITY.
IF INSTALLING MORE THAN 1 LIGHT, YOU MUST LINK YOUR LIGHTS FIRST, BEFORE INSTALLATION BEGINS. YOU MAY
LINK UP TO 6 LIGHTS. AFTER THE LIGHTS ARE LINKED YOU MAY BEGIN THE INSTALLATION PROCESS.
INSTALLATION
INSTRUCTIONS
Hardware Included
Plastic plug X 2
Screw X 2
Part
Light Fixture X 1
A
B
C
ITEM: Q08BN0301-08
3
Mounting the light
Mount the light on the screws (A) by placing the keyholes
on the back of the light over the screw heads.
x
x
96mm
B
A
Slide the power switch to the "OFF" position. Use a
Phillips head screwdriver to remove the 4 screws
holding the battery cover in place. Gently pull battery
pack away from the light fixture and disconnect the
battery connector. Replace old battery pack with a
new 6V AA Ni-Mh 900mAh rechargeable battery pack.
Connect the battery connector and insert battery pack
into the light fixture. Replace the battery cover by
aligning it properly and replacing the 4 screws
removed earlier. Slide the power switch to the “ON”
position.
For optimum performance, allow solar light to charge
in full sunlight.
A
Screws
Battery cover
Battery pack
Battery
connector
ON/OFF Switch
Link ON Switch
