Please read the manually carefully before using the focus light
Smart Focus 3000
Installing the Batter y
Inser t the batter y into the batter y slot,as shown in the
diagram below.
Warning!! The polarity of the batter y must match the
polarity of the contacts on the light。Make sure that the
positive and negative poles of the batter y aligh with the
positive and negative poles of the light.
GENERAL WARINGS AND INSTRUCTIONS
*
Do not disassemble the diving light。
*
To avoid leaks the
O-rings should be chec
k
ed to ensure that they are free
from any dirt, sand, hair and dust every time before you open and close
the light。Use a soft cloth to the O-rings if required。The O-rings should also
be carefully checked for cracks or blemishes。Gently and evenly apply a thin
coat of grease to the entire O-rings regularly to prolong O-ring life。Be care not
to scratch the O-ring surface。If cracks or blemishes occur, the O-rings should
be replaced immediately。
*
Do not open the light when using in the water
。
*
Wash the exterior of the light thoroughly with clean fresh water
immediately after use。Soaking the light in fresh water will help
to remove salt deposits prior to storage。
*
Do not disassemble, modify,remanfacture,puncture or damage
the device or batter y。
BATTERY WARNINGS
*
Remove the batter y if the light will not be used for long periods
of time (e,g., between dive trips)。
*
Do not use a sharp object to remove the batter y。
*
Keep the batter y away from children。
*
Contact your local waste disposal depar tment to dispose of the
light/batter y in accordance with applicable local laws and
regulations。
*
If using an extermal batter y charger, only use the WEEFINE
accessor y approved for your product。
*
Only replace the batter y with the correct WEEFINE approved
replacement batter y。Using an incorrect batter y presents a risk of
fire or explosion。
To purchase a replacement batter y, see your WEEFINE dealer or
the WEEFINE website。
Note: under the special working environment, when the light
beads of the high-power LED working in the confined space,
droplets maybe coagulated on the surface of glass. Please don't
worr y, this is the normal phenomenon.
Charging the Batter y
Step 1: Inser t the DC plug into the batter y. (As shown in
the diagram below)。
Step 2: Plug the charger into the wall outlet. The
charger's indicator will turn red signifying the charger is
receiving power。
Step 3: When the batter y has finished charging, the
charger's indicator will turn green.
Noted: Charge time is approximately 2.5 hours
Attention：
To protect the batter y and extend batter y life, please do
not charge the batter y for more than 12 hours。
20:07:14
Focus / Video light
USER MANUAL
