INSTRUCTIONS FOR:
CORDLESS 108 LED RECHARGEABLE
PORTABLE FLOODLIGHT LITHIum-IOn
MODEL No:
LED108C.V2
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you
years of trouble performance.
IMPORTANT:
PLEASE READ THESE InSTRuCTIOnS CAREFuLLY. nOTE THE SAFE OPERATIOnAL REQuIREmEnTS, WARnInGS AnD CAuTIOnS.
uSE THIS PRODuCT CORRECTLY AnD WITH CARE FOR THE PuRPOSE FOR WHICH IT IS InTEnDED. FAILuRE TO DO SO mAY CAuSE DAmAGE
AnD/OR PERSOnAL InJuRY AnD WILL InVALIDATE THE WARRAnTY. PLEASE KEEP InSTRuCTIOnS SAFE FOR FuTuRE uSE.
1.
SAFETY InSTRuCTIOnS
1.1. GEnERAL
Ensure the floodlight is correctly charged before initial use.
DO nOT
cover or block the lens during use.
DO nOT
turn the floodlight on when it is being re-charged.
DO nOT
shine directly into your, other person’s or animal’s eyes.
DO nOT
allow children to use the floodlight.
DO nOT
handle or move the floodlight whilst it is being charged.
DO nOT
use the floodlight if you suspect that the battery or the spotlight casing is damaged.
DO nOT
immerse the floodlight in water.
Ensure replacement batteries are genuine Sealey batteries of the same rating.
Ensure the floodlight is unplugged and allowed to cool before attempting any cleaning or replacement.
When not in use store the floodlight in a safe, dry, childproof location.
1.2. BATTERY SAFETY
WARnInG! To reduce the risk of burns or fire:
,
DO nOT
attempt to open, disassemble, modify or service the battery.
Ensure the charger is switched off and disconnected from the floodlight before attempting to open the lamp unit.
DO nOT
expose to temperatures above 60°C (140°F).
DO nOT
crush, puncture, short external contacts or dispose of in fire or water.
Replace only with the battery designated for this product.
Dispose of the old batteries in accordance with local authority battery regulations.
DO nOT
dispose of with regular refuse.
If the electrolyte in the cells contacts the skin, wash thoroughly with soap and water.
If the electrolyte in the cells gets into the eyes, rinse thoroughly with cool water and seek immediate medical attention.
1.3. ELECTRICAL SAFETY
USE ONLY THE SUPPLIED MAINS CHARGER PLUG FOR CONNECTING FLOODLIGHT TO THE MAINS POWER
SUPPLY. ONLY USE THE SUPPLIED ADAPTOR FOR CONNECTING TO A VEHICLE 12V ACCESSORY SOCKET.
WARnInG!
It is the user’s responsibility to read, understand and comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices. An RCCB (Residual
Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCD (Residual
Current Device) is used with all electrical products, particularly portable equipment which is plugged into an electrical
supply not protected by an RCCB.
You must
also read and understand the following instructions concerning electrical safety.
1.3.1.
The Electricity At Work Act 1989
requires all portable electrical appliances, if used on business premises, to be tested by
a qualified electrician, using a Portable Appliance Tester (PAT), at least once a year.
1.3.2.
The Health & Safety at Work Act 1974
makes owners of electrical appliances responsible for the safe condition of the
appliance and the safety of the appliance operator.
If in any doubt about electrical safety, contact a qualified
electrician.
1.3.3.
You must ensure that you:
Inspect the charger plug, cable and connector for wear and damage to ensure items are safe before connecting to the
mains power supply. If worn or damaged
DO nOT
use.
Check cables are always protected against short circuit and overload.
Important:
Check that the voltage marked on the charger plug is the same as the power supply to be used.
Uncoil the cable between charger and the floodlight.
DO nOT
pull the charger plug from the mains socket by the lead.
DO nOT
use any other type of charger with this product.
DO nOT
place the connector into any area of the floodlight except the correct jack inlet socket.
DO nOT
try to take the charger plug apart.
DO nOT
use the charger plug to charge or power any other electrical item.
DO nOT
get the charger wet, or use in wet, damp conditions (for indoor use only).
WARnInG!
nEVER
substitute a standard 13Amp 3 pin plug, or any other type of plug, for the charger plug.
Original Language Version
LED108C.V2 Issue: 1 - 15/01/14
© Jack Sealey Limited
