Activating station
Monitoring EVC information
Acknowledging faults
Retrieving faults
Acknowledging faults
1. If the fault pop-up is accompagnied with a buzzer
press the
SELECTION WHEEL (X) on the
control panel once to silent the buzzer.
2. Read the fault pop-up it will alternate between
“source of fault/cause of fault” and “actions to
take.”
CAUTION!
If a DANGER or WARNING pop-up
with request “Stop engine” appears, it is rec-
ommended to stop the engine at once.
3. Acknowledge the fault by pressing the
SELECTION WHEEL (X) on the control panel a
second time. The pop-up will disappear.
4. Take the recommended actions. Please refer to
the “Fault handling” chapter, section “Fault regis-
ter” in the operator’s manual.
NOTE!
All faults are erased when the starter key is
turned to the stop position (S).
NOTE!
Unattended faults will result in new fault pop-
ups every time the system is powered up or when the
engines are started.
Acknowledging faults on Docking Station
A flashing LED above the
ALARM ACKNOWL-
EDGE BUTTON indicates which engine (1/2/3) is
faulty. A more serious fault is also indicated with a
buzzer.
1. Acknowledge the alarm with the
ALARM
ACKNOWLEDGE BUTTON. The LED above the
button stops flashing and lights continuosly. The
buzzer is silenced.
2. Activate a station that is equipped with displays in
order to read and acknowledge the fault pop-up.
3. Take the recommended actions. Please refer to
the “Fault handling” chapter, section “Fault regis-
ter” in the operator’s manual.
Retrieving faults
Faults set in the system during a trip can be viewed
in the FAULTS MENU. Follow the instructions be-
low:
1. Select which engine (display 1/2/3) to check
for faults. Use the
DISPLAY SELECTION
BUTTON.
2. Press the
BACK BUTTON and you will
reach the FAULT view in the FAULTS AND
SETTINGS MENU (B).
NOTE!
A POINTING HAND-symbol in a view
indicates a SUB-MENU. if there is no fault
(FAULTS 0) in the FAULTS veiw there is no
SUB-MENU for FAULTS.
3. Press the
SELECTION WHEEL (X) and
you will enter the SUB-MENU for FAULTS (C).
4. Turn the
SELECTION WHEEL (A) and
view the faults set in the system.
NOTE!
When in a menu other than the MONITOR-
ING MENU (A),
push the BACK BUTTON to return
to previous menu. Push repeatedly and you will re-
turn to the
MONITORING MENU (A).
B
C
AB Volvo Penta
SE-405 08 Göteborg, Sweden
X 1
3
NOTE!
This pocket guide contains short
version of some of the panel and dis-
play instructions found in the operator’s
manual for Volvo Penta IPS triple instal-
lation. This pocket guide is not meant to
be a substitute for the instructions in the
operator’s manual, it is only meant to be
a memory aid. Read the operator’s man-
ual thoroughly before using this pocket
guide.
Volvo Penta IPS
triple installation
s
s
s
s
A
POCKET GUIDE
2
1
3
2
1
2
3
1
2
3
