INSTRUCTIONS FOR
INSTALLATION AND OPERATION
MODELS
AND
HEAVY-DUTY WALL MOUNTS
GENERAL
SCOPE
The information in this instruction manual
covers the installation of Models
and
Heavy-Duty Wall Mounts, as well as
Associated Equipment and Accessories.
INTRODUCTION
Models
and
Heavy-Duty
Wall Mounts are designed to support
and-tilt drives, scanners, camera/lens
systems, and environmental housings with total
camera station load ratings of up to 200 pounds
(91 kg) for the
and 100 pounds (45 kg)
for the
These industrial, outdoor
units are constructed of weatherproof aluminum
or corrosion-protected steel.
ASSOCIATED EQUIPMENT
AND ACCESSORIES
MOUNTING ACCESSORIES
Model
Corner Mounting Bracket:
For corner mounting capabilities.
Model
Support Strut:
Provides
added strength for heavy loads. Can be used
alone or with corner mounting bracket.
Model
Pole Mounting Adapter:
Accommodates pole diameters from 4 to
inches (10.2 cm to 25.4 cm).
INSTALLATION
WALL MOUNT
GENERAL INSTRUCTIONS
Bolts should preferably extend through the
structure with nuts and washers used on the
opposite side. Studs should be either
anchored in concrete or welded to steel. If
the mount is to be attached to a blind
structure, make certain that the fasteners
used have a minimum pull-out strength of 1500
pounds each. (Never use lag screws in the end
grain of wood.)
AND
WALL MOUNTS
To install either the
or
Wall
Mount, secure the base to the wall with four
lag
screws or hex bolts (or studs).
See Figure 1.
When the mounting surface does not provide
adequate strength for the wall mount, use
Model
Support Strut. The
Corner Mounting Bracket is available for
corner installations. See Figure 2.
NOTE: Use stainless steel
for all
outdoor-
part number
Product
to change
INDUSTRIES INC.
525 BROAD HOLLOW ROAD, MELVILLE, N.Y. 11747 TEL: (516) 293-2200 TELEX: 144581
TOLL FREE:
800-645-9116 (OUTSIDE OF NEW YORK)
