Headquarters:
4675 Vandenberg Dr., N. Las Vegas, NV 89081 • (800) 932-2358 or (702) 651-1304 • Fax (702) 651-1303
www.VicenzaDesigns.com
INSTRUCTIONS FOR INSTALLATION
INCLUDED PARTS
1- Privacy Latch
2- Face Plate
3- 2 Wood Screws
4- C-Clip (on latch)
5- 2 Nylon Self-Alignment Plugs
6- Mounting Bracket Plate
7- Mounting Bracket Plate with Posts
8- Privacy Spindle
9- 2 Machine Screws
10- Knob or Lever
11- 2 Nylon Spindle Guides/Trim Nut Bushings
12- 2 Trim Nuts
13- Privacy Rosette
14- 2 Set Screws
15- Trim Nut Key
16- Privacy Pin
17- Allen Wrench
INSTRUCTIONS
1. Remove C-clip from side of latch, inside room to be locked. Insert latchinto 1” edge bore of door.
Secure face-plate over latch button with twowood screws. (Figure 1)
2. Insert privacy spindle (temporarily) for accurate mounting bracket tightening.
3. Insert nylon self-alignment plugs into both mounting brackets. (Figure 2)
4. Slide mounting brackets over spindle and fasten with machine screws. (Orient mounting brackets to
show machine screw heads inside room to be locked.) Once mounting brackets are tight, remove
self-alignment plugs and discard or set aside for additional installation. (Figures 3,4)
5. Remove spindle for easier rosette installation. Place rosette over mounting bracket and align peg into
mounting bracket hole. Place trim nut through rosette and screw into mounting bracket. Before
tightening, make certainprivacy hole on rosette lines up with privacy hole on latch (where
C-clip remains). Secure with trim nut key, taking care to not scratch rosette. Place privacy pin through
privacy hole on rosette and screw into threadedhole on latch.
6. Place nylon spindle guide (knob) or trim nut bushings (lever) into trim nuts.
7. Align V-grooves on privacy spindle, facing downward. Insert from inside of room to be locked, until
notched stop is resting against latch. If spindle is not fully inserted, handle will not function properly.
8. Place knob or lever over spindle and secure with set screw using provided Allen Wrench. Start with knob
or lever in locked side of room, while pulling spindle from other side, to prevent spindle from shifting.
Please note that set-screw should already be installed in knob or lever.
CARE
Clean only with a soft, dry cloth. To protect the finish, we do not recommend the use of polishes or abrasives.
If you have any questions regarding your Vicenza Designs product, please contact your local dealer.
Product(s):
DHPR8000,
DHPR8001, DHPR8002,
DHPR8003, DHPR8004
Rev:
21Aug12
San Michele
DHPR8000
NOTE:
For doors thicker than 1 3/8”, a longer spindle
is required. Contact your dealer or retailer to order.
