Toro 137-1019, Installation Instructions Manual

Page: 1 / 24

Form No. 3423-453 Rev A
Water Seal Kit
Workman ® HDX and HDX-Auto Utility Vehicle Cab Kit
Model No. 137-1019
Installation Instructions
Installation
Media and Additional Parts
Description Qty. Use
CVT-intake hood assembly (Workman
HDX-Auto machines only)
1 Installing the CVT-intake hood assembly.
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Raise or remove the bed from the machine (if
equipped).
Note:
Refer to the machine Operator’s Manual
for more detailed information on raising and
removing the bed.
4. Shut off the engine and remove the key.
5. Disconnect the battery; refer to the Operator’s
Manual .
Note:
Disconnect the negative terminal first.
6. While grasping the hood in the headlight
openings, lift up on the hood to release the lower
mounting tabs from the slots in the bumper
(
Figure 1 ).
g010314
Figure 1
1. Hood
7. Pivot the bottom of the hood upward until you
can pull the top mounting tabs from the frame
slots (
Figure 1 ).
8. Pivot the top of the hood forward and unplug the
wire connectors from the headlights (
Figure 1 ).
9. Remove the hood.
© 2018—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3423-453* A