![background image](http://html1.mh-extra.com/html/tork/din-100/din-100_quick-start-manual_1130326001.webp)
WIRING DIAGRAM
To begin setting the unit, remove the clear
cover by lifting up from the bottom.
Insert a pin into the reset opening to clear all
memory. After a few seconds, all numbers
across the top (days of week) will flash.
TO SET CLOCK
NOTE REGARDING DAYLIGHT SAVING TIME:
A manual daylight saving time adjustment is
provided for your convenience and may be used
at your option. Inserting a pin in the DST open-
ing will advance the clock by 1 hour. A + 1h will
appear on the display. Pressing this recessed
key again will turn the clock back 1 hour to its
original setting.
If you are setting the clock during a standard
time period (NOV- MAR) set the clock for the
current time. When daylight saving arrives in
April, you can press the DST key and the clock
will advance 1 hour. A + 1h will appear on the
display. When daylight saving time is over in
October, press the DST key and the clock will
turn back 1 hour to standard time. The + 1h will
disappear from the display.
If you are setting the clock during a daylight sav-
ing time period (APR - OCT) set the clock one
hour earlier. Then press the DST key and the
clock will advance 1 hour to the correct daylight
saving time. A + 1h will appear on the display.
At the end of daylight saving time in October,
press the DST key and the clock will turn back 1
hour to standard time. The + 1h will disappear
from the display.
To set the clock you must keep Clock (CLK) key
pressed while the following settings are made:
1 - Press DAY key to set current day.
1= Monday............ 7= Sunday
2 - Press Hour (HR) key to set current hour. Be
sure to check for AM or PM. If AM or PM
does not appear, the unit is in a 24 hour
military mode. To change it to AM/PM,
insert a pin in the DST opening and press
the hour key.
1
2
3
4
5
SPDT
TIMER
SUPPLY
CHANNEL 1
TORK DIN 100
DIGITAL TIME SWITCH
7 DAY
DIN RAIL MOUNTING
TECHNICAL DATA
Number of Channels: 1
Total number of ON and OFF events: 20
Switching Interval: 1 Minute
Manual Override: to the next scheduled event or
permanently.
Input Voltage: 120 VAC, 50/60 Hz
Power Consumption: 5 VA MAX.
Output:
Switch Configuration: SPDT (unpowered)
Switch Contact Rating: 16A Resistive
Battery Backup: 150 Hours
Battery Type: Rechargeable Ni-Cd
Operating Temperature:
14° to 140° F (-10° to 55° C)
Accuracy at 68° F: + /- 2.5 seconds/day
Dimensions: 1-7/16”w X 2-7/8”d X 3-1/4”h
Weight: 4 oz.
INSTALLATION
CAUTION:
1. INPUT WIRES TO CONTROLLER MUST
BE DEDICATED, i.e. NO OTHER LOAD
CONNECTED TO THE SAME CIRCUIT.
2. UNIT IS TO BE INSTALLED BY A
LICENSED ELECTRICIAN
DIN RAIL MOUNTING # 50022 (35 mm)
Locate red clip on back of unit and push it down.
Mount unit to DIN rail. Push red clip up from bot-
tom to lock unit onto rail. To remove from rail,
push entire unit straight up thereby forcing the
red clip down to the open position.
For surface
mounting, a small din rail is provided.
35mm
27mm
1 mm
7.5mm
6.3mm