Sunleaves SunDial4 240v
Digital Multi-Timer
Thank you for choosing to grow with Sunleaves!
Your satisfaction and success are important to us. For
best results, carefully read the following instructions
before using your Sunleaves SunDial4 Digital Timer.
Features of your SunDial4 Digital Timer:
• 240V
• Up to twenty different ON/OFF cycles
• Variable day of the week programming
• Rechargeable Ni-MH battery stores settings in case of power loss
Using the Sunleaves SunDial4 Digital Multi-Timer
To set the current day and time:
1. Hold “SET” for three seconds.
2. Navigate to the correct day with the arrow buttons.
3. Press “SET.” Adjust the hour with the arrow buttons.
4. Press “SET.” Adjust the minute with the arrow buttons.
5. Press “SET” again to finalize the day and time adjustment.
If the time was set incorrectly, repeat this process.
Note: This device uses 24-hour (“military”) time as its default display mode.
Hold “TIME” for three seconds when the current time is displayed to toggle between 24-hour and 12-
hour time modes.
To program ON/OFF cycles
1. Press the right arrow button until “PROG” is displayed and “1 ON” is blinking. “1
ON” indicates that you are programming the start day and time of the first timed
cycle.
2. Press “SET.” Adjust ON operation days with the arrow buttons.
3. Press “SET.” Adjust starting hour with the arrow buttons.
4. Press “SET.” Adjust starting minute with the arrow buttons.
5. Press “SET.” Press the right arrow button. “1 OFF” will begin blinking, indicating
that you are adjusting the end day and time of the first timed cycle. Repeat steps
3-4 to program OFF time.
Continue this process for up to 20 separate ON/ OFF cycles, which will display as
“2 ON,” “2 OFF,” “3 ON,” “3 OFF,” etc. Pressing the “MANUAL” button at any point
during the setting process will cancel the currently-selected set time. Press the right
