![background image](http://html.mh-extra.com/html/stream/sv8w/sv8w_quick-start-manual_1383860001.webp)
SV8W Quick Start Guide
Web: www.steamaustralia.com.au
1
SV8W
SV8W Display
SV8W Hose Controls
_______________________________________________________________________________________________
Preparing the SV8W
Steam Operation:
1. Plug cable into a wall outlet.
NOTE:
Do NOT use multi-outlet power-boards and
avoid using low-quality extension cables.
2. Open water tank filler cap (
iii
), fill tank with clean
tap water up to the top then close filler cap.
NOTE:
Do NOT use de-mineralised water and do NOT
fill with any chemicals.
3. Turn SV8W on using the ON/OFF switch (
i
), making
sure the steam level lights on the display (
g
) light up
after a few seconds.
4. Connect hose into the SV8W by opening the
protective plastic flap located on the front of the
machine (
ii
) and pushing the plug end of the hose in
with the round red button on the top side of the hose
until it clicks.
Proceed to “Vacuum Operation” and/or “
Water Injection
Operation
” secti
on if you are planning on using the vacuum
and/or water injection functions together with the steam
functions.
Vacuum Operation:
1. Turn the vacuum on from the hose controls by
quick-pressing (
V
).
The SV8W will make a beeping noise and
the vacuum waste tank lights
(
b
) will flash on the display.
2. Open the transparent
vacuum cover (
iv
), remove
blue foam filter and slowly fill
clean tap water into the
rectangular hole on top of the
vacuum waste tank until the
vacuum waste tank lights (
b
)
stops flashing.
3. Replace the blue foam filter
and the transparent vacuum cover (
iv
).
NOTE:
If the vacuum waste tank
lights (
b
) still flashes after filling
the tank up, remove the plastic
part with the rectangular hole,
then remove the plastic divider
underneath. You will see a
white float, make sure the
white float’s surrounding areas
and the float itself is clean and
can move freely. Re-assemble
the waste tank, fill the tank with clean tap water until
the vacuum waste tank lights (
b
) stops flashing then
put the blue foam filter and transparent vacuum
cover (
iv
) back on.
Hose Handle Operations
Steam Functions:
1. After 5-
6 minutes the ‘Steam Ready’ lights (
d
) will
light up on the display and the steam function is ready
for use. Make sure the steam level lights (
g
) is on,
otherwise quick-press the
RED
steam button (
S
) until
the steam level lights turn on to prepare the steam
function for use.
2. If the SV8W makes a beeping noise
and the ‘Low
Water’ lights (
c
) flashes, proceed to Step 2 of
“Preparing the
SV8W
| Steam Operations”.
3. Press and hold the
RED
steam button (
S
)
to select
between 3 steam levels: low, medium, or high. The
steam level lights (
g
) display will light up in
correspondence to the different steam levels:
1
=
Low,
2
= Medium and
3
= High.
4. Once you have selected which steam levels you
want, press the trigger located underneath the hose
handle (
T
)
to release steam from the nozzle.
WARNING: Do NOT operate hose with steam nozzle
pointing at persons, animals or electrical machinery
[S]
[L]
[V]
[T]
[i]
[ii]
[iii]
[iv]
[f]
[g]
[e]
[b][c][d]