background image

SUBMERSIBLE

SWIMMING POOL DRAINER

O   W   N   E   R ’   S

M   A   N   U   A   L

INSTALLATION, OPERATION & PARTS

MODEL PCD-10B

Pentair Water Pool and Spa, Inc.

© 20

10

, Pentair Water Pool and Spa, Inc. All rights reserved. This document is subject to change without notice.

1620 Hawkins Ave., Sanford, NC 27330  • (919) 566-8000
10951 West Los Angeles Ave., Moorpark, CA 93021 •  (805) 553-5000

Technical Support

:

 (800) 831-7133

Sta-Rite

®

and Pentair Water Pool and Spa

®

are registered trademarks of Pentair Water Pool and Spa, Inc. and/or its affilitated companies in the

United States and/or other countries. Unless noted, names and brands of others that may be used in this document are not used to indicate an
affilitaion or endorsement betweent the proprietors of these names and brands and Pentair Water Pool and Spa, Inc. Those names and brands
may be the trademarks or registered trademarks of those parties or others. Printed in U.S.A.

04-14-10                                                                                                                                                                                                                  

S9

58 

(Rev. B)

Use of electrical appliances around swimming pools

is hazardous. To reduce the risk as much as possible, carefully
read and follow all instructions in this manual or on your pump. 
Use of this manual will reduce service requirements and chance
of injury and will lengthen the life of your pump.

Summary of Contents for PCD-10B









Reviews: