Spectrum Digital XDS510USB, Installation Manual

Page: 1 / 11

1
XDS510USB JTAG Emulator
Installation Guide
IMPORTANT INFORMATION
About This Installation Guide
This Installation Guide is for the XDS510USB Emulator product. The XDS510USB Emulator
is a module to be attached to a PC for hardware engineers and software programmers to develop
DSP applications.
The text paragraphs in this Guide are very important for proper device functioning and for
preventing any possible damages on the XDS510USB Emulator device and project target board.
These paragraphs are shaded as in the following example. Please carefully read each of the
shaded text.
This is an example of a very important text paragraph mentioned above.
Introduction
Overview
XDS510USB Emulator is designed to use with digital signal processors (DSPS) operating at
1.0-5.0 volts. The emulator itself is a bus-powered USB device. It is fully plug and play
compatible and is fully powered by the host computer’s USB connection. The XDS510USB
Emulator operates with TI Code Composer Studio IDE debug tool and is fully compatible with
windows 98/SE/ME/2000/XP/VISTA.
Features
XDS510USB Emulator has the following features:
●
Supports Texas Instruments DSP with a JTAG (IEEE1149.1) interface: C2000, C5000,
C6000 ,OMAP platforms.
●
Supports Texas Instruments Code Composer Studio.
●
Supports 1.0-5.0 volt DSP devices.
●
USB compatible. Simple Connection, fully Plug-and-Play compatible-no jumpers, noswitch
settings.
●
Hot pluggable
●
Power provided by USB bus , no additional power supply is required.