Can work for Round
and Square Poles
•
Round Lamp Mount
Diameter 1.6 in - 2.4 in
•
Square Lamp Mount
Side length 1.2 in - 1.6 in
SOLPAD
INSTALLATION MANUAL
10W/1080LM
PLEASE READ AND FOLLOW INSTRUCTIONS FOR PROPER OPERATION
SAVE THIS MANUAL FOR FUTURE REFERENCE
NOTICE & WARNING
INSTALLATION
1. The SOLPAD will provide optimal usage where there is enough sunshine.
2. Please note the lighting time depends on sunshine duration and weather
3. The lamp will light up automatically at dusk
4. Built-in intelligent IC is with over-charge, over-discharge and over-voltage protection.
5. The lamp is equipped with an internal battery pack, which is replaceable.
6. If needed, please contact for correct new battery pack.
7. If the battery is taken out and put back in or replaced with new batteries, please allow the
solar panel to receive maximum sunshine to activate the lamp.
8. Non-professionsals please do not disassemble the lamp.
9. Please do not dispose the battery with household garbage to avoid explosion.
WALL MOUNT
YOU WILL NEED TO DRILL
HOLES UP TO .3 in in Diameter
•
Use the Allen Wrench to loosen the bracket (PICTURE 1)
Adjust it to the appropriate angle (PICTURE 2) and
Screw tightly after (PICTURE 3)
•
Use the Allen Wrench to loosen the light panel
Pull it out and adjust to your demanded lighting angle (PICTURE 4)
Then fix screws tightly (PICTURE 5)
•
Fix lamp onto wall or lamp-post (see picture 6)
POLE MOUNT
1
6
2
3
4
5
REACH EN62471
