instructions for
air polisher Ø180mm 2500rpm
model no:
sa17/s.V2
Thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. saFeTY
WarNiNG!
ensure Health & safety, local authority, and general workshop practice regulations are adhered to when using this
equipment.
WarNiNG!
disconnect from air supply before changing accessories or servicing.
9
maintain the polisher in good condition (use an authorised service agent).
9
replace or repair damaged parts. use genuine parts only. unauthorised parts may be dangerous and will invalidate the warranty.
9
use in a suitable, clean and tidy work area, free from unrelated materials. ensure that there is adequate lighting.
9
Before each use check pad for condition. if worn or damaged replace immediately.
WarNiNG!
Always wear approved eye or face and hand protection when operating the polisher.
9
use face, dust, or respiratory protection in accordance with cosHH regulations.
9
noise level may be high - wear safety ear defenders.
9
Remove ill fitting clothing. Remove ties, watches, rings, other loose jewellery and contain and/or tie back long hair.
9
Wear appropriate protective clothing and keep hands and body clear of pad.
9
Maintain correct balance and footing. Ensure that the floor is not slippery and wear non-slip shoes.
9
Keep children and unauthorised persons away from the work area.
9
ensure workpiece is secure before operating the polisher. never hold a workpiece by hand.
9
Avoid unintentional starting.
WarNiNG!
ensure that correct air pressure is maintained and not exceeded. recommended pressure is 90psi.
9
Keep air hose away from heat, oil and sharp edges.
9
check air hose for wear before each use and ensure that all connections are secure.
9
Prolonged exposure to vibration from this polisher may pose a health risk. it is the owner’s responsibility to correctly assess the
potential hazard and issue guidelines for safe periods of use and offer suitable protective equipment.
8
Do NoT
use a polishing pad which has a speed rating less than the speed rating of the polisher.
8
Do NoT
use the polisher for a task it is not designed to perform.
8
Do NoT
operate polisher if any parts are damaged or missing as this may cause failure and/or personal injury.
8
Do NoT
carry the polisher by the hose, or yank the hose from the air supply.
8
Do NoT
force, or apply heavy pressure to the polisher, let the polisher do the work.
8
Do NoT
operate polisher when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
Do NoT
carry the polisher with your finger on the power lever.
8
Do NoT
direct air from the air hose at yourself or others.
9
When not in use, disconnect from the air supply and store in a safe, dry, childproof location.
2. iNTroDucTioN
Polished and well balanced aluminium body with two side handle mounting positions. trigger operated throttle control. supplied with
Ø180mm backing pad.
3. speciFicaTioNs
model no: ..............................................................
SA17/S.V2
Pad size: ................................................................. Ø180mm
thread size: .............................................................
5/8”UNC
free speed : .............................................................
2500rpm
Air consumption: ......................................................... 5.3cfm
operating pressure: ...................................................... 90psi
inlet size: ...................................................................
1/4”BSP
Weight: .............................................................................
2kg
n
oise power/pressure:
.......................................
100/89dB(A)
Vibration/uncertainty:
.........................................
2.39/0.7m/s²
V
acuum outlet: ..................................................................
n/a
s
A17/S.V2 | Issue 5(L) 06/10/17
Original Language Version
© Jack sealey limited
refer to
instruction
manual
Wear eye
protection
Wear ear
protection
Wear a mask
Wear
protective
gloves
