background image

 

WARNING! 

Ensure Health & Safety, local authority and general workshop practice requirements are  

  adhered to when using this equipment. Familiarise yourself with the application and limitations, as well as  
  the potential hazards of the kit.

 

This kit is suitable for flaring copper, brass, steel or thin walled aluminium pipe. 

 

 

Maintain the

 

kit in good condition.

  Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will  

  invalidate the warranty.

  Locate the flaring tools in a suitable work area, keep the area clean and tidy and ensure there is adequate  

 lighting.

 

WARNING! 

Always wear approved eye or face protection when using the flaring tools.

  Keep children and unauthorised persons away from the working area.

 

DO NOT

 use the kit for any purpose other than for which it is designed.

 

DO NOT

 use the kit if any parts are damaged or missing as this may cause failure and/or personal injury.

 

DO NOT

 allow untrained persons to use the kit.

 

DO NOT

 attempt to flare piping when you are tired, under the influence of alcohol, drugs or intoxicating  

 medication.

 

When not in use clean kit components, replace in case and  

  store in a safe, dry, childproof area.
  Remember! The safe operation of a vehicle, or other   
  equipment, may well depend on the quality of the flare  
  produced. Discard any flare which is mis-formed or cracked in any way.

 WARNING! The warnings, cautions and instructions discussed in this 

  manual cannot cover all possible conditions and situations that may occur. 
  It must be understood that common sense and caution are factors which 
  cannot be built into this product, but must be applied by the operator.

INSTRUCTIONS FOR:  

ON CAR HYDRAULIC 

PIPE FLARING TOOL  

MODEL No:

 

PFT10

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these 

instructions and properly maintained, give you years of trouble free performance.

IMPORTANT:

 

PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL 

REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE, FOR THE 

PURPOSE FOR WHICH IT IS INTENDED. 

FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. 

PLEASE KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

  1.  SAFETY INSTRUCTIONS

  2.  INTRODUCTION & SPECIFICATIONS

 

Produces accurate automotive SAE and DIN flares 
on 3/16” and 4.75mm pipes respectively. Small body 
makes it ideal for splicing in replacement sections of 
brake pipe on-vehicle. Features a hydraulic ram 
which also makes it suitable for steel pipes.

Part  

Description 

Dies: 

3/16” SAE, 4.75mm DIN.  

 

Original Language Version

PFT10  Issue: 2(L) - 29/11/13

© Jack Sealey Limited

Reviews: