360° mini pen light rechargeable
7 smd + 1w smd led
model no:
led3607g
thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. safety
1.1.
general safety
9
ensure the light is fully charged before initial use.
8
dO nOt
turn the light on when it is being charged.
8
dO nOt
shine directly into your, other person’s or animal’s eyes.
8
dO nOt
allow children to use the light.
8
dO nOt
handle or move the torch whilst it is being charged.
8
dO nOt
use if you suspect that the battery or the light’s casing is damaged.
dO nOt leave battery in a discharged state, recharge battery immediately. before storage, fully recharge the battery,
subsequently recharge the battery at least once every six months of non-use.
1.2.
electrical safety
Use only the USB charging lead supplied to charge the battery.
warning!
It is the user’s responsibility to read, understand and comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices.
An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCd
(Residual Current device) is used with all electrical products, particularly portable equipment which is plugged into an electrical
supply not protected by an RCCB.
You must also read and understand the following instructions concerning electrical safety.
1.2.1.
The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
electrician, using a Portable Appliance Tester (PAT), at least once a year.
1.2.2.
The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
1.2.3. You must ensure that you:
9
Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply.
8
dO nOt
use if worn or damaged.
1.3
battery safety
warning!
To reduce the risk of burns or fire:
8
dO nOt
Attempt to open, disassemble, modify or service the battery pack.
8
dO nOt
Crush, puncture, short external contacts or dispose of in fire or water.
8
dO nOt
expose to temperatures above 60°C (140°).
9
Replace only with the battery pack designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool
water and seek immediate medical attention.
2. intrOductiOn
Unique and innovative 360° swivel ball joint function enables the light source to be positioned in any direction. exclusive patented design
owned and registered to Sealey. each lamp houses 7 super bright Smd leds providing up to 200 lumens output, illuminating the whole
work area. Includes an additional high power 1W led in the end to use as a directional torch. Features a belt clip with integrated magnet on
the back of the light and a strong magnet on the bottom which allows hands free operation. High quality 1.1Ah lithium-ion battery for longer
life, no memory effect and a much slower discharge than traditional ni-mh batteries. micro USB charging port. Supplied with charging lead.
batteriespecificatiOn
Original Language Version
© Jack Sealey limited
Refer to
Instructions
led3607G Issue:1 21/07/18
