www.routerboard.com
1
04
-
Mar
-
17
RouterBOARD OmniTik UPA-‐5HnD
Quick Setup Guide and Warranty Information
The RouterBOARD
OmniTik
comes preinstalled in an outdoor case, with a built-‐in 5GHz 802.11a/n
wireless and five 10/100 Ethernet ports which support MDI-‐X auto detection. There are two built-‐
in antennas. One antenna is v-‐pol, the other is h-‐pol. Antenna gain is 7.5dbi. The device is pack-‐
aged with a 24V power adapter, a PoE injector, a mounting bracket and a hose clamp.
First use
•
Open the small door on the bottom of the case, connect an Ethernet cable to the Ether-‐
net port. If you want to connect more than one Ethernet cable, you have to break out the
hole-‐blockers.
•
OmniTik accepts 11-‐30V Passive PoE from a PoE injector. The package includes a 24V
power adapter and a PoE injector.
•
The default IP address from LAN is 192.168.88.1 for configuration
•
Username is
admin
and there is
no password
Powering
The board accepts powering from the Ethernet port (Passive PoE):
•
Ethernet port accepts passive Power over Ethernet 11-‐30V DC. Package contains a 24V
adapter and a PoE injector.
Maximum power consumption of the device is 11W.
Power output
The OmniTik UPA-‐5HnD can supply PoE powering to external devices from its Ethernet ports. This
is convenient as you don't need any additional PoE injectors on a tower to power other wireless
devices. This feature is indicated by the letter “P” in the device model name. The output Voltage
will be the same as input Voltage, and this feature will have to be enabled on the specific ports in RouterOS software. By default
it is disabled. Output is possible on ports 2-‐5. Once Power Output is enabled in RouterOS, the Ethernet LED light turns from
Green, to Red. Read LED means the port is currently providing PoE power.
Note: Due to a design flaw, OmniTIK UPA power LED
(red) turns on on the incorrect port. Port 2-‐5 power out LEDs are reversed, ie. enabling power out on port 2, LED 5 will turn red.
Power out will correctly be given to port 2 as configured, only the LED order will be reversed.
Booting process
This device doesn't come fitted with a Serial Port connector, so initial connection has to be done via the Ethernet cable, using
the MikroTik Winbox utility. Winbox should be used to connect to the default IP address of
192.168.88.1
with the username
admin
and no password.
In case IP connection is not available, Winbox can also be used to connect to the MAC address of the device. Information here:
http://wiki.mikrotik.com/wiki/First_time_startup
In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the RESET button of the device
when starting it until the LED light turns off, and the device will start to look for Netinstall servers.
Mounting
OmniTik comes bundled with one mounting bracket and one hose clamp for putting the device on a pole. You should avoid con-‐
necting a loose Ethernet cable to the Ethernet port, secure the cable to a wall or the pole, so that the cable weight is not pulling
