Installation Guide_OM7320
1. Unpacking
Remove the scanner and its accessories from the box and
packing material. Refer to the packing list to make sure
you have received all the items ordered. Visually inspect
the scanner and accessories for any evidence of physical
damage. Make sure that the scanner interface
corresponds with the host system interface. Immediately
contact your supplier if anything appears to be damaged,
or if the supported interface does not correspond with the
host system interface.
1. Scanner 4. Interface Cable
2. Bracket 5. Power Adapter
3. Screws
6. User’s Manual
2. Connecting The Scanner
To properly connect the scanner, do the following:
1. Plug the interface cable (in Port 1 ) and ensure the scanner
is properly connected to the host.
2. Connect the power adapter. The scanner will automatically
activate and detect the setup interface.
3. Press the Volume Button repeatedly to adjust the
frequency and volume level.
Use the illustration below to see where to connect your
cable(s) to the scanner.
a.
Sleep/Wake Button
Press this button for 3 seconds, the scanner manually enters
sleep mode.
When a sleep mode time-out is programmed, the scanner can
be activated by pressing this button. Moreover, the scanner
may be automatically activated when any barcodes or objects
pass-by the scanner.
NOTE: The default value for the sleep mode time-out is set to 10
minutes. When the scanner is in sleep mode, the LED is
intermittently flashing blue.
b. LED
A blue LED indicates that the scanner is ready to read a
barcode. An orange LED indicates a good read.
c. Volume Button
The beep is heard whenever data has been read correctly. The
frequency and volume can be adjusted.
3. Installing The Scanner On A Counter
Surface
To install this scanner on a counter surface, follow the
instructions below.
1. Remove the bracket from the back of the scanner.
2. Place the bracket on a counter surface and fasten the
bracket to the surface with three screws as
illustrated in the figure.
NOTE : Use the bracket as a template to mark the
places for the mounting holes at the counter
surface and drill three holes.
