P.O Box 578 Casino, NSW, 2470 Australia
Phone: International ++614 2902 9083
Australia (04) 2902 9083
Website:
http://rcs-rc.com
E mail:
TX-2
Digital Proportional R/C
TABLE OF CONTENTS
PROVIDED IN INSTRUCTIONS.
Page # 1 Introduction.
Page # 2 Preparing the TX-2. Binding.
Page # 3 Preparing & driving Live Steam locos.
Page # 4 Connecting servos.
Page # 5 Using with a Centre off battery R/C ESC.
Page # 6 Using with a Low off battery R/C ESC.
Other instructions for use with battery R/C are
found with the ESC.
http://www.rcs-rc.com/pages/instructions
Thank you for purchasing this DSM2 3 channel TX handpiece.
INSTRUCTION MANUAL
THESE INSTRUCTIONS REFER SPECIFICALLY TO THE
DELTANG R/C
BASED TX-2 HANDPIECE.
They should be read in conjunction with the RCS ESC you are using.
SWITCH SETS THE DIRECTION.
300º KNOB CONTROL OF REGULATOR.
1 X FULL THROW SERVO FOR WHISTLE.
REMOVE REAR OF TX-2 TO INSERT
THE 9 VOLT BATTERY.
LED BLINKS WHEN BATTERY LOW.
A HIGH QUALITY 9V SNAP IS USED.
WHEN USED FOR BATTERY R/C
LARGE KNOB HAS CENTRE “CLICK” OFF
WITH 150º EITHER SIDE SETS THE
DIRECTION & SPEED.
3 X BUTTONS FOR SOUND TRIGGER.
FOR USE WITH “CENTRE OFF” BATTERY R/C ESC’s & MOST RCS “LOW OFF” ESC’s.
THE TX-2 IS NOT SUITABLE FOR USE WITH LIVE STEAM LOCOS.
THE TX-2 IS GUARANTEED FOR ONE YEAR.
When used for battery R/C you will supply a locomotive or trail car, the 14 – 20 volt traction batteries (depending on ESC), a fuse,
ON-OFF switch and wires where necessary, to connect the ESC to the battery and motor(s).
Where soldering is necessary, we recommend a low wattage soldering iron and resin core solder.
TO AVOID CONFUSION WITH OTHER OPERATORS, WE SUGGEST YOU MARK THE TX TO SHOW WHICH LOCO IT IS OPERATING.
CAUTION
DO NOT ATTEMPT TO ALTER THE TUNING OF THE RADIO EQUIPMENT.
DO NOT USE RADIO CONTROL EQUIPMENT IN THUNDERSTORMS.
CHILDREN UNDER 12: ADULT SUPERVISION RECOMMENDED DURING USE.
!!
RCS TX & RX PRODUCTS MUST NOT BE USED FOR CONTROLLING RIDE ON LOCOMOTIVES CAPABLE OF
CARRYING MEMBERS OF THE GENERAL PUBLIC.
