RAMPAGE
P
R
O
D
U
C
T
S
Installation Instructions
P/N 77015 Tailgate Bar Kit
1987-2006 Jeep Wrangler
Rampage Products Corona, CA 92883
Phone: (951) 277-4949 Fax: (951) 277-2295
www.rampageproducts.com
Made in China
Included:
1 - Tailgate Bar
2 - Tub Brackets (1 left, 1 right)
1 - Rubber Weather Strip
1 - Mini Tonneau (with buckles)
4 - Machine Screws
4 - Flat Washers
4 - Star Washers
Installation:
Step 1:
Remove Contents from box and verify all components are
present. Read through instructions fully prior to installation.
In some cases the holes on the Tailgate Bracket will line up
with existing holes or dimples in the tub of the vehicle. In
this case, use the existing holes as pilots to drill 3/16" holes
on the vehicle.
NOTE: Carefully check under the drilling area to
be sure you do not drill into any concealed wiring.
If you are replacing a hardtop, use the Tailgate Bracket as
a template to drill 3/16" holes. Position Tailgate Bracket
onto the tub by lining up the inside edge with the edge of
the tailgate opening. See Figure 1 for location.
Install 2 machine screws through the bracket and through
the tub. Install 1 flat washer, star washer and nylock nut on
each. Push bracket down while tightening. See Figure 2.
Repeat this step for opposite side.
If installing the optional mini tonneau cover, slide the plastic
strip sewn onto it into the square channel on the backside
of the tailgate bar now. See Figure 3 and 4.
Slide the Tailgate Bar onto the bottom of the rear window.
The Tailgate Bar has a C channel (See Figure 4) built into
it, slide this onto the flap with a small tube at the bottom of
the window. See Figure 5. Center the Tailgate bar to the
window.
Continued on Page 2.
Step 2:
Tailgate
Bracket
Location
Figure 1
Step 3:
Figure 2
Figure 2
Line Up
Line Up
Push
Down
Push
Down
Figure 3
Figure 3
Slide
Slide
Step 4:
4 - Nylock Nuts
2 - Sheetmetal Screws
C Channel
Figure 5
Figure 5
Figure 4
Square
Channel
