background image

WCM-060 Instruction Manual 

For programming information:

 

Wired system Programming Guide 

 

For general overview: 

Wired RAK Application Sheet

 

What is the WCM-060? 

The WCM-060 wired keypad is six button keypad for use with wired 
system to control curtains and blinds. It will transmit Fade Up/Fade 
Down and Off in two rooms before any custom programming is 
added.  
 
WCMs require a RAK-LINK to operate as part of the system.  WCMs 
(as part of the wired network generally) can be wired in two ways:  
 

“Daisy Chain” configuration - 

A single run of keypads runs from the 

RAK-LINK and to an end point. It is still usually advisable to run a 
return leg back to  
the RAK-LINK as a spare. 

  

 

“STAR” configuration - 

Cables are all run back to a central point: a RAK-STAR usually 

located with the RAK-LINK. Each cable can be from a single keypad or a leg of keypads. 

 

Installation Note:  

The WCM comes in two sections “Front” and “Back” they are referred to as such in the following 
installation guide.  The “Back” section is just a connection board for the CAT5/6 cable. The “Front” 
section contains all memory and programming. 

WCM-060

Manual Version 2.0.2 

Summary of Contents for WCM-060

Page 1: ...erally can be wired in two ways Daisy Chain configuration A single run of keypads runs from the RAK LINK and to an end point It is still usually advisable to run a return leg back to the RAK LINK as a spare STAR configuration Cables are all run back to a central point a RAK STAR usually located with the RAK LINK Each cable can be from a single keypad or a leg of keypads Installation Note The WCM c...

Page 2: ...inate the WCM as required See Terminating the WCM on page 4 of this manual The back section of the WCM is now installed and is ready for the front section and cover plate TIP Take care when preparing and installing not to disturb the punchdown connections Loops are provided on the back section to cable tie the cable s if desired Step 4 Clip the front section of the WCM into the grid and connect th...

Page 3: ...e 4 of this manual Step 3 The back section of the WCM is now installed and is ready for the front section and cover plate TIP Take care when preparing and installing not to disturb the punch down connections Loops are provided on the back section to cable tie the cable s if desired Step 4 Clip the transparent surrounding mounting plate and the WCM front board together Fit the WCM front board and a...

Page 4: ...re configuration For the example the WCMs marked STAR TERM on page one Programming the WCM The WCM is programmed using the Rasoft Pro programming software A WA WTC Bridge is required for any programming of a wired system Wired system Programming Guide For information on how to programme the wired system using Rasoft Pro Troubleshooting the Wired Network Sometimes cabling problems or incorrectly pu...

Reviews: