![background image](http://html1.mh-extra.com/html/racelogic/labsat-rllsp01/labsat-rllsp01_manual_3145135001.webp)
10 - LabSat Replaying GPS Data
Note: Applicable to RLLSP01 and RLLSR01 LabSat Models.
Any LabSat unit can replay a recorded scenario file to any connected GNSS device capable of receiving the L1 GPS/
Galileo signal.
Note: LabSat is designed for direct connection to a GNSS receiver via a suitably screened cable. If testing is to
be performed on GNSS equipment without an external antenna connection, it is the responsibility of the user to
ensure that this is done in a fully RF screened environment.
Contact Racelogic for more information.
The LabSat is connected as illustrated in the diagram below:
1. Connect the high speed USB cable from the LabSat to the computer the Scenario data file will be replayed from.
2. Connect power to the LabSat, and the recipient GNSS device.
3. The LabSat comes supplied with a number of adaptor cables which allow connection to a number of GNSS
devices. Select the appropriate antenna cable for the device to be connected.
4. Connect the RF-OUT connector of the LabSat (illustrated below) to the GNSS antenna input of the device.
5. Start the LabSat software.
6. The LabSat is now ready to replay GNSS data to the DUT (Device under Test). Select the Replay Mode tab on
the LabSat. The LabSat is now ready to replay GNSS RF data.
https://racelogic.support//LabSat/LabSat__-_User_Manual/10_-_LabSat_Replaying_GPS_Data
1