Preface
ADSD-S-S
1
Preface
Thank you very much for purchasing ADSD-S-S series servo products. This manual
provides related contents on how to use our ADSD-S-S servo drive and ADSM-S motor.
Before using the product, please read this user manual thoroughly to ensure correct use,
incorrect use may cause abnormal operation or shorten the service life, even directly damage
the product.
Please store this manual in a safe and handy place for quick reference whenever
necessary.
Safety information
WARNING indicates a dangerous situation that can result in death, serious physical injury or
equipment damage.
CAUTION indicates a potentially dangerous situation that might possibly result in bodily harm or
equipment damage. This is also available for safe operation of not guarding.
Safety precautions:
Carefully note and observe the following safety precautions when receiving, inspecting, installing,
operating, maintaining and troubleshooting.
Receiving inspecting
CAUTION
☆
In order to prevent fire hazard and accidents, please form the wiring by the
cable specifications outlined in this user manual.
Installation
As a hazardous voltage may remain inside the drive, electrical equipment should be installed and
inspected only by qualified personnel. Do not maintain the internal circuit before the capacitance
finishing discharging.
Preface
ADSD-S-S
2
CAUTION
☆
Do not use the product in a wet location or where have corrosive and
inflammable gases or liquids. Failure to observe this caution may result in
electric shock, fire, or personal injury.
Wiring
WARNING
☆
The drive and motor’s grounding terminal should correctly connect to the
ground according country electrical safety requirements. Failure to observe
this caution may result in electric shock, fire, or personal injury.
CAUTION
☆
Do not connect any power supplies to the U, V, W terminals. Failure to
observe this precaution may result in serious injury, damage to the drive or
fire.
☆
Ensure that all screws, connectors and wire terminations are secure on the
power supply, servo drive and motor. Failure to observe this caution may
result in damage, fire or personal injury.
Operation
WARNING
☆
In order to prevent accidents, the initial trial run for servo motor should be
conducted under no load conditions (separate the motor from its couplings
and belts).
☆
Do not approach or touch any rotating parts (e.g. shaft) while the motor is
running. Failure to observe this precaution may cause serious personal
injury.
☆
Before starting the operation with a mechanical system connected, change
the drive parameters to match the user-defined parameters of the
mechanical system. Starting the operation without matching the correct
parameters may result in servo drive or motor damage, or damage to the
mechanical system.
☆
Ensure that the emergency stop equipment or device is connected and
working correctly before operating the motor that is connected to a
mechanical system.
☆
Do not touch either the drive heat sink during operation as they may
become hot and personal injury may result.
Maintenance and inspection
WARNING
☆
Do not touch any internal or exposed parts of servo drive and servo motor
as electrical shock may result.
☆
Do not remove the operation panel while the drive is connected to an
electrical power source otherwise electrical shock may result.
