V1.0
8873242
Please read and understand all instructions before use. Retain this manual for future reference.
SPECIFICATIONS
Load Capacity
500 lb
Adjustable Height
(6 adjustable height)
31.5, 32.63, 33.63, 34.5, 35.25,
35.87 in.
Overall Length
41.5 in.
Overall Width
22.87 in.
Folded Dimensions
41.5 x 3.5 x 38.5 in.
Material
Steel
Finish
Powder coating
SAFETY
WARNING! Read and understand all instructions before
using this tool. The operator must follow basic
precautions to reduce the risk of personal injury and/or
damage to the equipment.
Keep this manual for safety warnings, precautions, operating
or inspection and maintenance instructions.
1. Use the correct tool for the job. This tool was designed
for a specific function. Do not modify or alter this tool or
use it for an unintended purpose.
2. Operate in a safe work environment.
3. Do not operate any tool when tired or under the
influence of drugs, alcohol or medications.
4. Lock tools away and keep out of the reach of children.
5. Do not exceed the weight capacity.
UNPACKING
WARNING! Do not operate the tool if any part is missing.
Replace the missing part before operating. Failure to do
so could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and
inspect for damage. Make sure that all items in the
Identification Key are included.
IDENTIFICATION KEY
A Crossbar (2)
B
Bolt, M6x32 (4)
C
J-Bolt, M8x38 (4)
D Washer, 8x3.0x30 (4)
E Bolt, M8x75 (2)
F
Leg (4)
G Nut, M6 (4)
H Chain (2)
I
Nut, M8 (2)
ASSEMBLY/INSTALLATION
1. Insert a J-bolt through the bolt hole near the leg’s (F)
narrow end. Secure with an M8 nut (I). Repeat with other
three legs. The bolt opening must face the narrow end.
2. Insert a leg into each end of both crossbars (A), aligning
the narrow end bolt holes. Insert an M6x32 bolt (B)
through each side and secure with M6 nuts.
3. Place both assembled pieces down flat with the J-bolts
facing each other. Place one set of legs inside the other,
then align the bolt holes.
4. Slide a washer onto each M8x75 bolt (E). Insert each
through the leg’s bolt hole. Slide a washer over each
bolt’s end and secure with an M8 nut (I). Open and close
legs to ensure the nut is not too tight.
5. Place the end links of each chain onto the J-bolts.
Squeeze the J-bolts to close the openings around the
chain links.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or
replace damaged or worn components. Only use identical
replacement parts when servicing.
WARNING! Only qualified service personnel should
repair the tool. An improperly repaired tool may present
a hazard to the user and/or others.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool
does not function properly or parts are missing. If unable to
do so, have a qualified technician service the tool.
