I
V-O2 HOLDER INSTALLATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
IV-O2 Holder Installation Instructions
B10320E-I Revision B
©GF Health Products, Inc., June 2005
1
SAFETY GUIDELINES - PLEASE READ BEFORE USE
WARNING: Important! Read and understand these instructions before installing or
using the IV-O2 holder. Ensure that the IV-O2 holder is installed as de-
scribed in the following paragraphs before use. If the IV-O2 holder is not
properly installed, personal injury and/or property damage could result.
WARNING: Do not use this product without proper instruction from a healthcare pro-
fessional.
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or
injury caused by improper installation, assembly or use of this product.
WARNING: If components are damaged or missing, contact your Graham-Field Health
Products dealer immediately. DO NOT use substitute parts.
Install O2 holder on sideframe
1. Install O2 holder (lower section of
IV-O2 holder) on left-rear-sideframe
lower rail: Insert U-bolt over the
lower rail, then through O2 holder
lower bracket as shown in picture at
right. Install washers and wing nuts
on U-bolt ends, securing O2 holder
to lower rail.
2. Install O2 holder on sideframe
backpost: Insert U-bolt over back-
post, then through O2 holder upper
bracket as shown in picture at right.
Install washers and wing nuts on
U-bolt ends, securing O2 holder to
left backpost.
3. Tighten all four wing nuts until
holder is secure on sideframe. Ensure
that O2 holder is securely attached to
sideframe before proceeding.
install O2 holder
(lower section)
backpost
u-bolt
u-bolt
upper
bracket
lower bracket
washer
wing nut
lower rail
left
sideframe
