Installation
Wireless Antenna
Mount the antenna in a high location, in line-of-
sight with the wireless remote and in the center
of the coverage area. Avoid areas where the radio
signal must pass through fencing, stucco walls,
reinforced block walls, etc.
1. Open the antenna door and connect cable
wires to the removable terminal block using
this color-coded sequence:
Pin #
Wire Color
1
Green
2
Yellow
3
Orange
4
Red
5
Blue + Brown
6
Black + Purple
2. Remove the wire clamp and feed the wire into
the left-most position, leaving about 12” of
extra cable in the box. Push the wire into the
rubber grommet seal. Reinstall the clamp and
close the box.
3. Route the antenna cable to the EOS Command
Center and in through the low voltage
compartment.
4. Unscrew and swing down the hinged board
plate to access the circuit boards.
5. Connect the antenna wire to the removable
terminal on the command center board using
the same pin/color sequence. To connect
multiple remotes with the antenna, install a
RBC Hub Card (part #E36).
For installations with multiple antennas, the wires
can terminate at the Command Center or be wired
to the terminal block of another antenna or wired
remote (max. 2000 ft.).
After all connections are complete, power-up
the EOS Command Center to verify that
communication has been established.
Polaris
®
EOS
®
Wireless Antenna and Remote
Installation Instructions
Removable
Terminal
Block
Grommet
Wire Clamp
E
SVC
High Power Relay 1
High Power Relay 2
High Power Relay 3
High Power Relay 4
Optional
High Power
Relay 6
GND
SNS1
GND
SNS2
GND
SNS3
GND
SNS4
GND
SNS5
+
24VDC
GND
PRE
OUT
Optional
High Power
Relay 7
Optional
High Power Relay 5
Or 2 Speed
Pump Relay
Optional
High Power
Relay 8
Or 2 Speed
Pump Relay
HP1
HP2
HP3
HP4
HP5
HP6
HP7
HP8
LP6 LP5 LP4 LP3 LP2 LP1
VL
V1 V
LV2 VL
V3 VL
V4 VL
V5 V
LV6
Command
Center
To Antenna
Wire
Connector
Lock
Down
on
Wire
