TM
1
9580-A2-GZ40-10
June 1999
FrameSaver
SLV 9580 T3 ATM DSU
Installation Instructions
Document Number 9580-A2-GZ40-10
June 1999
Installation Checklist
Installation of the FrameSaver SLV 9580 DSU requires the following steps:
Verify the contents of the shipping carton
Mount the DSU in a cabinet or on open rails
Connect the DSU to a power source
Monitor the power-up self-test
Connect the DSU to its DS3 interface
Connect the DSU to its DTEs
Connect the DSU to an Ethernet interface
Connect the DSU to a terminal or PC, directly or through a modem
Enter a device profile
Set up system Login IDs and access levels
Configure the system
— Configure management PVCs and any other unique PVCs
— Enter and configure VPI/VCIs if your switch does not support traffic
descriptors
— Configure and run Auto-Configuration
Connect the DSU to its monitor and NetScout Probe, if used
Test the system
At any step, diagnose and correct any errors.
Physical installation is described in this document. For detailed configuration and
troubleshooting information, see the
FrameSaver SLV 9580 T3 ATM DSU User’s
Guide (9580-A2-GB20).
