1
USERS MANUAL
For English speaking countries only
P & P Full Body Sit Harness
Thank you for purchasing this P&P F u l l B o d y Sit Harness. Please take time to familiarize yourself with the
correct attachment, positioning and adjustment procedure.
It is imperative that this P&P Full Body Sit Harness is only used
for its intended purpose and that it is subject to a periodic recorded detailed inspection by a competent person.
To avoid personal injury, prior to using this P&P Full Body Sit Harness or training others to use it, CAREFULLY READ
and understand these instructions. If there is anything you do not understand, DO NOT use this P&P Full Body Sit
Harness, contact the supplier or P&P for further details.
Certain information in this manual is governed by law and is subject to change without prior notice. Great care has
been taken to ensure that the information is correct at the time of publication. However, it is the user’s sole
responsibility to ensure that they fully comply with all legal requirements. P&P will not accept liability for any
inaccuracy or incorrectly stated legal requirements.
P&P operate a policy of continual improvement and reserve the right to change specifications without notice. The
Manufacturer and / or their recognised agents, directors, employees or insurers will not be held liable for
consequential or other damages, losses or expenses in the connection with or by reason of or the inability to use the
P&P Full Body Sit Harness for any other purpose.
Note; training should only be delivered by a suitably qualified and competent person, ie a P&P products trainer.
Introduction:
The P&P Full Body Sit Harness has been designed for your safety, and will provide comprehensive
protection whatever your situation. The harness is designed to support the body and distribute force to
prevent serious injury in suspension work and fall arrest. In the event of a fall it will keep the worker in a safe
position ready for rescue. This harness must only be used in conjunction with an energy absorber or force
limiting device. Maximum all up weight 150kG. Recommended anchorage strength 15kN.
Fall Arrest:
Certified fall arrest points are clearly marked with an “A”. The rear “D” is your primary attachment point.
Although the front “D” connection is permitted for fall arrest it is primarily for work positioning and close
connections, such as ladder climbing and rescue.
Work Positioning:
Side “D” rings are for work positioning only, and not fall arrest.
Suspension:
The front suspension “D” is to be used for suspended work and when used as a sit harness.
Ascender/CROLL attachment:
The P&P Full Body Sit Harness is supplied with two front attachments for attachment of a CROLL ( n o t
s u p p l i e d ) or similar EN567 ascending device. Refer to the device instructions for full user instructions.
Suspension Seat Attachment:
Two loops located near the front suspension “D” allow the user to safely connect to a suspension seat.
Warning
Suspension seat attachments must not be used for fall arrest or work positioning purposes
If in doubt please clarify application with P&P technical support.
