PahaQue Custom Shop, Inc
A-Frame Trailer Side Tent
SETUP INSTRUCTIONS
Locate the following parts included with your A-Frame Side Tent:
Main tent body
1 extendable roof pole
2 Fixed –length roof poles
2 side/corner poles with pegs on one end
1 fiberglass arch pole
2 strips of Velcro
First Time Installation: (If you have already installed your Side Tent, skip to step #3)
1.
Locate the two strips of ‘loop’ Velcro. You will attach
these to the top edges of the sidewall.
*Note: Clean the edges of the sidewall with glass cleaner
or rubbing alcohol first. Allow to completely dry.
2.
With the sidewall in the lowered position, start at
the apex of the side wall and affix Velcro strips to
sidewall edges, removing the adhesive backing as
you go. Photos A and B
Side Tent Set Up Procedure
: (Follow these steps after initial installation is complete)
3.
With the sidewall still lowered, locate the center
edge of the Side Tent that has the Velcro sewn in.
Place the center of that edge on the apex of the
trailer. Continue attaching Side Tent edge.
4.
At this time, erect the trailer sidewall, and be sure to
properly lock into place. Photo C
5.
Locate and assemble fiberglass arch pole. Install this
pole into the front pole sleeve and insert each end
into the elbow connectors on either side of tent.
6.
Next, locate the extendable roof pole and step inside
the tent. This goes in the center of the ceiling with
the capped end in the pocket nearest the trailer and
the “C” clip extending through the front wall and
