CONGRATULATIONS!
You’ve purchased the finest in natural lighting technology
with your new OttLite
®
product.
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form
and return it today by mail, or register online by going to:
OttLite.com/warranty.
NOTE: THIS UNIT IS FULLY ASSEMBLED
1. Remove lamp from packing for use on a horizontal table.
2. Connect AC adapter input (G) into connector (H) in
the rear bottom of the lamp.
3. Plug the AC adapter (F) into a standard household
120V AC outlet.
Note: Only use with the supplied
AC adapter to avoid damage or fire.
4. Turn the lamp ON & OFF using power switch (B)
located on the front of the base (A). Power switch
(B) is a “touch” switch that controls LED brightness
setting.
5. To power LED settings, slightly touch the switch to
achieve the following:
• turn lamp “ON” to 1st brightness setting; touch the
switch “once”;
• for 2nd brightness setting; touch the switch “two-
times”;
• for 3rd brightness setting; touch the switch “three-
times”;
• to turn lamp “OFF”; touch the switch “four-times”.
6. To reposition the shade, hold base (A) steady and
grasp the shade (C) and lift to make adjustment.
7. Refer to diagrams for lamp maximum adjustment
range.
NOTE: DO NOT FORCE the shade outside
adjustable range indicated, as excessive adjustment
may cause damage.
SAFETY WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS
1. Turn off and WAIT UNTIL LAMP HEAD (C) IS COOL
before handling.
2. The LED panel (E) might get hot after several hours of
continuous use,
DO NOT place your hands directly on
LED light panel.
3. Never use with an extension cord unless the plug can be
fully inserted into the receptacles in the extension cord.
4. Do not alter the plug.
5. The lamp head included with this unit cannot be
replaced by the consumer.
6. INDOOR USE ONLY
ENGLISH
Dimmable LED Task Lamp
INS-21-0636
REV022521
Dimmable LED Task Lamp
CSY1300C CSY13WGC CSY13WGC-SHPR CSY1321C-SHPR CSY1381C-SHPR
K5
NOTE: The important safety instructions appearing in
this instruction sheet are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense, caution, and care must
be used with any electrical product.
CAUTION!
IF THE EXTERNAL FLEXIBLE CABLE OR CORD OF THIS LUMINAIRE
IS DAMAGED, IT SHALL BE EXCLUSIVELY REPLACED BY THE MANUFACTURER OR ITS
SERVICE AGENT OR A SIMILAR QUALIFIED PERSON IN ORDER TO AVOID A HAZARD.
CAUTION!
THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT REPLACEABLE; WHEN
THE LIGHT SOURCE REACHES ITS END OF LIFE THE WHOLE LUMINAIRE SHALL BE REPLACED.
FCC PART 15
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that the interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
CAUTION:
Any change or modification to product not expressly
recognized by OttLite Technologies voids OttLite’s responsibility for
proper function of product
CAN ICES-005 (B)/ NMB-005 (B)
AC/DC ADAPTER
Input: AC 100-240V, 50-60Hz, 0.5A
Output: 27V DC 0.4A with Male DC plug
C
E
A
B
H
G
F
