INSTRUCTIONS
FOR INSTALLING A HEAVY LOCK PLATE KIT IN
A
NATIONAL VENDORS@,
CROWN
cc,
CANDY CUPBOARD, CROWN
ELITE AND GOLDEN CABARET
MANUAL CANDY MERCHANDISER
CHECK THE PARTS RECEIVED IN THE KIT WITH THE PARTS LIST
IN THESE INSTRUCTIONS. I F ANY PARTS A R E MISSING, CONTACT
NATIONAL VENDORS' PARTS DEPARTMENT IMMEDIATELY.
These instructions cover the procedure for installing a
Heavy Lock Plate Kit in a Crown Line Manual Candy
Merchandiser.
Read these instructions carefully and thoroughly
before installing the Kit. Retain these instructions for part
number and installation information.
Kit, Heavy Lock Plate, part number 112-2424,
contains the following parts:
Part Number
Description
Quantity
11 2-2421
Heavy Lock Plate Assembly
1
114-1046
Lock Keeper Screw
2
11 2-2425
Installation Instructions
1
* * *
TO INSTALL THE KIT
A. PARTS REMOVAL
1. Open the Cabinet Door and lower the Door
Holder Leg.
Be sure the Door Holder Leg is rotated into the Down
Position before proceeding to the next steps. Shifting
the weight of the Delivery Mechanism to the front
could cause the Cabinet to tip
personal
injury and equipment damage.
2. Rotate the Delivery Mechanism out of the Cabinet
as follows:
a.
Remove the Money Box
b. Remove the two Thumb Screws which attach
the top rear of the Delivery Mechanism to
two brackets located
on
the upper inside rear
wall of the Cabinet.
c. Disengage the Stops located at the front
bottom
flanges of both the Left and Right
Sidewall and slide the Delivery Mechanism
straight out of the Cabinet, until it strikes the
spring of the Pivot Stop
on
the left side.
d. Pivot the right side of the Delivery Mechanism
out of the Cabinet.
3.
Remove two attaching Screws and the standard
Lock Plate Assembly from the Mounting Bracket
on
the right wall of the Cabinet.
B.
INSTALLATION O F
THE
KIT
1.
Attach the Heavy Lock Plate Assembly, part
number 112-2421, to the Mounting Bracket
on
the right cabinet wall with the two Lock Keeper
Screws, part number 114-1046. Both parts are
included in the Kit. See Figure.
2. Return the Delivery Mechanism to the In-Cabinet
position
as
follows.
a. Pivot the right side of the Delivery Mechanism
toward the rear of the Cabinet until the front
o f the Delivery Mechanism is parallel to the
Base and the Shelf of the Cabinet.
b. Push the Delivery Mechanism straight into
the Cabinet, carefully maintaining alignment
in both the Left and Right Mounting Bracket
Assemblies
on
the floor
of
the Cabinet Shelf.
MOUNTING
RIGHT CABINET WALL
LOCK KEEPER SCREW
1 14-1 046
RIGHT CABINET WALL
LOCK KEEPER SCREW
1 14-1 046
HEAVY LOCK PLATE ASSEMBLY
112-2421
FIGURE
1
Printed
in U.S.A.
C o p y r i g h t
b y N a t i o n a l Vendors
A
Division of
UMC
Industries,
112-2425
