Cable Power Enclosure
Model: CTEG8-240MB
Eight Battery Ground Mount Enclosure w Meter Base, 240VAC
Quick Reference Guide
Safety
Only trained service personnel should install and maintain the power enclosure and electronics.
Any modifications to this unit not expressly approved by Myers Power Products could void the warranty.
Failure to observe these warnings may result in serious injury, death or damage to the equipment.
This is a “quick reference” only. Detailed instructions are available by contacting a Myers representative.
Unpacking
Unpack the enclosure upon receipt. Notify the carrier if there is any damage.
Check the package contents. The package contains the enclosure, battery cables, connectors and associated
hardware, and this product documentation.
Installing the enclosure
Install a preformed or pour a concrete pad according to best industry practice.
If installing the enclosure on the matching Myers pre-formed pad, place the enclosure on the pad. Align
the bolt holes in the enclosure base to the anchor hooks on the pad. Fasten the enclosure to the pad
using the appropriate hardware.
Wiring the enclosure
Install and interconnect ground rods appropriate for proper grounding
according to local engineering and electrical code requirements.
Typically, the local AC utility will connect the AC line to the Meter Base.
As the enclosure is pre-wired, no additional wiring should be required.
A licensed electrician must make any AC wiring changes that may need to
be made.
Installing the Coax Cable
Remove the coax housing raceway by removing the coax raceway fastener from inside the enclosure.
Route the coax from the pad to one of the coax bushings. A 90 degree pin-connector will be required to
terminate the cable. The pin-connector will fasten to the coax bushing with the pin entering the enclosure.
After securely tightening all connections, replace and secure the coax raceway to the enclosure.
Myers Power Products Tel: 610-868-3500 Service: 610-868-5400 Toll Free: 800-526-5088 January-2008 Page 1
Doc# 114537
