1/3
LH72 Change of display resolution (polarity)
When the display is , press key to select the addition display.
Press key to select a condition.
When you have made your selection, press key to save your settings.
To finish the basic settings, follow steps
③
and
④
below.
Set to basic setting mode.
Turn
key "ON" while the AC adapter is energized.
Press and hold
key for 3 seconds after the lamp changes from blinking to off.
The display will be
. (additional display).
LH72 Change of display resolution (polarity)
Ver.3 (2021.1) CS&S
LH72-3
* If you do not know the output resolution of the measurement unit, refer to the separate "Initial setup manual".
Purpose of change
Operation
Explanation
Change the polarity for each input axis
while using the addition function
Change the selection of addition display in the basic
settings
Change the measurement unit resolution
Change the length measurement unit resolution in
the basic settings. And check the display resolution
in the detailed settings.
Change the display resolution
Change the display resolution in the detailed
settings
Change the display polarity
(Counting direction is reversed)
Change the display resolution in the detailed
settings
Diameter display (double count value)
Change to diameter display with display resolution
in the detailed settings
Detailed settings
⇒
Display resolution
⇒
Change
Detailed settings
⇒
Display resolution
⇒
Diameter display
The operation method for changing the display resolution differs depending on the purpose and conditions of the change.
Select the purpose and conditions to be changed from the table below and perform the operation.
Basic setting
⇒
Measurement unit resolution
⇒
Change
Basic settings
⇒
Addition display
⇒
Change
Detailed settings
⇒
Display resolution
⇒
Change polarity
Basic settings
⇒
Addition display
⇒
Change
Input 3 - Input 2
Input 2
Input 3
Input 2 + Input 3
Input 2 - Input 3
- (input 2 + Input 3)
Addition display (input conditions to
be displayed on the Z axis)
①
②
If you press key once, it will automatically enter the advanced setting mode and display.
Press key to enter normal count mode.
③
④
Switch from basic settings to normal count mode.
Press
key once and the display will change to
.
Press
key once and the display will change to
.
About 2 sec
Power ON
