32-Zone LED Wireless Keypad Module
MG32LRF V1.1 Installation Guide
The MG32LRF is a two-way wireless keypad that provides the same functionality as a hardwired keypad
including system programming. The MG32LRF is compatible with the Magellan 32-Zone Wireless Transceiver
Control Panel (MG5000 V1.30 or higher).
Step 1: Powering the Keypad
A. Installing the Backup Battery
With the backplate removed, install the 3.7Vdc Li-ion rechargeable backup battery included in the box.
Please note that this can be replaced by a standard cell phone type battery. The backup battery is for
backup purposes only. It is not the primary power source.
B. Connecting the DC Source (Primary Power Source)
When connecting the DC source, use a 6Vdc adapter only. Do not use a 16Vac transformer. Connect a
typical 6Vdc cell phone charger/adapter to the terminals located below the backup battery.
Compatible Nokia DC power supplies: ACP-8U, ACP-12U, ACP-8E, ACP-12E, and AC-3U.
C. Battery Charging Indicator
The [ ] key of the MG32LRF will light up to indicate that the backup battery is charging only after DC
restoration.
Step 2: Assigning the Keypad
Automatic Assignment
If there is no hardwired keypad or no learned wireless keypad, the control panel will open a 10 minute
window for Automatic Assignment after panel power-up. Press and hold the [ ] and [
BYP
] key for three
seconds. The control panel has learned the keypad(s). Up to 4 wireless keypads can be assigned within
the ten minute window.
Standard Assignment
Press [
ENTER
]. Enter your [
INSTALLER
CODE
] or [
MAINTENANCE
CODE
].
Go to section(s) [570] = Keypad 1, [571] = Keypad 2, [572] = Keypad 3, or [573] = Keypad 4.
Press and hold the [ ] and [
BYP
] key for three seconds on the respective keypad to learn it to the panel.
The control panel has learned the keypad. Alternatively, enter the serial number of the MG32LRF into
one of the four sections to learn it to the panel.
Backup battery
(3.7Vdc Li-ion)
Primary Power source
terminals (6Vdc)
MG32LRF without backplate
MG32LRF with backplate
Future Use Firmware Upgrade
