FM
Madas Technical Manual
- 6|6.3 - REV. 0 of 1
th
Oct 2018
1.0 GENERAL INFORMATION
This manual shows you how to safely install, operate and use the device.
The instructions for use
ALWAYS
need to be available in the facility where the device is installed.
ATTENTION: installation/maintenance needs to be carried out by qualified staff (as explained in
section 1.3) by using suitable personal protective equipment (PPE).
For any information pertaining to installation/maintenance or in case of problems that cannot be solved with the instructions,
contact the manufacturer by using the address and phone numbers provided on the last page.
1.1 DESCRIPTION
A device that retains dust particles conveyed by the gas and protects the elements in danger (burners, counters, boilers,
pressure regulators, etc.) from rapid clogging.
IT consists of a filter cartridge made of washable synthetic material and can be entirely removed for full inspection, cleaning
and/or replacement.
It can be supplied equipped with:
• pressure test nipples and/or connections to control the pressure and/or differential pressure.
• cap or drain valve for condensation drainage.
• clogging indicator differential pressure gauge installation set-up;
• pressure gauge already installed.
Reference standards: EN 126 – EN 13611.
1.2 KEY TO SYMBOLS
ATTENTION:
Attention
is drawn to the technical
details
intended
for
qualified staff.
DANGER:
Failure to observe this may
cause damage to tangible goods, injury
to people and/or pets.
DANGER:
Failure to
observe this may cause
damage
to
tangible
goods.
1.3 QUALIFIED STAFF
These are people who:
• Are familiar with product installation, assembly, start-up and maintenance;
• Know the regulations in force in the region or country pertaining to installation and safety;
• Have first-aid training.
1.4 USING NONORIGINAL SPARE PARTS
• To perform maintenance or change spare parts (e.g. filter element, O-ring, etc.)
ONLY USE
manufacturer-recommended
parts. Using different parts not only voids the product warranty, it could compromise correct operation of the device.
• The manufacturer is not liable for malfunctions caused by unauthorised tampering or use of non-original spare parts.
1.5 IMPROPER USE
• The product must only be used for the purpose it was built for.
• It is not allowed to use fluids other than those expressly stated.
• The technical data set forth on the rating plate must not, under any circumstances, be exceeded. The end user or installer
is in charge of implementing proper systems to protect the device, which ensure the maximum pressure indicated on the
rating plate is not exceeded.
• The manufacturer is not responsible for any damage caused by improper use of the device.
