Warranty void if not installed as per installation instructions
INSTALLATION INSTRUCTIONS
Lumascape Lighting Industries Pty Ltd
38-44 Enterprise Street, Cleveland, QLD 4163, Australia
PO Box 1875, Cleveland D.C., QLD 4163, Australia
T
07 3286 2299
F
07 3286 6599
E
W
www.lumascape.com.au
IN0094 - 28 May 2014
Copyright ©2014 Lumascape Lighting Industries Pty. Ltd. ABN 21 010 572 773
www.lumascape.com.au
LS431LED:
Surface Mount Remote Gear
IP66 / IP67
A.C.N. 0105 72 773
MODEL:
LS431LED
INPUT VOLTAGE:
Remote Driver
SPOTLIGHT & FLOODLIGHT
2.
IP67
B
C
A
A
LS6097 remote constant current LED driver
(or Lumascape approved equivalent)
cable strip length
120 mm
6 mm
4 mm² max per terminal
IP67
B
C
A
A
LS6097 remote constant current LED driver
(or Lumascape approved equivalent)
cable strip length
120 mm
6 mm
4 mm² max per terminal
Punch gland holes:
Depending on your requirements punch out one or two holes and
install gland(s) as shown in illustration below.
1.
IP67
A
1 or 2
Secure base and tighten entry gland:
Drill mounting holes for luminaire. Feed the cable through the gland and
tighten as shown in illustration. Repeat this process if a secod gland is
installed. Ensure a correct sized, round cable (
Ø
5-10 mm) is used or seal
will not be IP67. Screw down luminaire base. Ensure gasket seal is inserted
between surface and luminaire base.
Wire up luminaire to supply cable. Please note that the single colour LED
luminaire will be supplied with a terminal block. For the RGB verions wire
nuts (not supplied) must be used to make the connection between the
luminaire to the supply cable.
Refer to wiring diagram 1.0 for
conductor colour and designation.
DANGER
ISOLATE LUMINAIRE FROM POWER
Failure to isolate power
supply before installation or
maintenance may result in
fire, serious injury, electric
shock, death and may
damage the luminaire.
1x LS431LED
COMPONENTS
x4
screw
gland
x2
x2
x1
Allen key
gasket seal
All connections must be kept dry;
failure to do so may result in product
reliability issues
This is an above ground luminaire and
no part of it should be below ground
level or covered in soil or mulch
CAuTiON: luminaires can become
very hot. use discretion in placement
WARNiNGS
Refer to Wiring
Diagram(s) 1.0
COMMON
RED
GREEN
BLUE
DC
RGB Remote Driver
Wire Colour
Designation
Red
Red +
Orange
Red -
Green
Green +
White
Green -
Blue
Blue +
Black
Blue -
Single Colour Low Voltage
Wire Colour
Designation
Yellow
+
Blue
-
Wiring Diagram 1.0
fit gasket seal
