Installation Instructions
1 |
P a g e
PIER LED 12V DECK LIGHT
SKU# 220450, 220451
Rated Voltage 12V
NOTE:
This fitting is 12V extra-low voltage and can be DIY.
This installation instruction applies to the 12V side of the fitting only.
When working with 240V, a licensed electrician is required.
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before using the product. Please keep instructions for future reference.
Warranty
•
This light fitting is covered by a 3 year warranty. The warranty is from date of purchase, not the date of installation.
Please retain proof of purchase.
•
Warranty will be void if there is any damage due to improper usage or modification to the fitting.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void
warranty.
Installation requirements
•
All wiring and installation of the light fitting must adhere to local and national wiring rules.
eg. AS/NZS 3000:2007/Amendment 2:2012 Electrical installations.
•
Do not exceed the maximum wattage rating.
•
This fitting is rated IP65. This must be maintained during installation.
•
Replace any cracked protective lamp shade to maintain IP rating when using this fitting.
•
Select a suitable location for installation:
-
This product is suitable for indoor or outdoor use.
-
This fitting is protected against water penetration to IP65 standards, which is jets of water from any direction.
-
This fitting is not designed to be immersed in water. Ensure the fitting is installed in a location where the water
can be easily drained away.
-
The connectors on the wiring kit are not designed to be immersed in water or installed under any soil or
concrete. Ensure the connectors are positioned in a location where the water can be easily drained away.
-
This fitting can be used where normally flammable materials, including building insulation, are or maybe
present, but cannot be abutted against any material and cannot be covered in normal use.
-
Take note of the clearance values. Do not remove any structural members for the installation of this product.
RISK OF FIRE
– BUILDING INSULATION MUST NOT COVER THIS LUMINAIRE
HCB = 20mm MIC = 20mm SCB = 10mm SCI = 10mm
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure there are no components missing before
assembling. If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the fitting has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
•
Ensure power to the circuit you are working on has been switched OFF, before commencing any electrical work.
