![background image](http://html.mh-extra.com/html/leviton/58a00-1/58a00-1_installation-instructions_1886598001.webp)
MINI TRANSMITTER
Cat. No. 58A00-1
Installation Instructions
DI-021-SY481-05A
AR2253
(58I00-1)
WARNINGS AND CAUTIONS
• Read and understand all instructions. Follow all warnings and instructions
marked on the product.
• Do not use this product near water - e.g., near a tub, wash basin, kitchen sink
or laundry tub, in a wet basement, or near a swimming pool.
• Never push objects of any kind into this product through openings, as they may
touch dangerous voltages.
• Never install communications wiring or components during a lightning storm.
• Never install communications components in wet locations unless the
components are designed specifically for use in wet locations.
• Never touch uninsulated wires or terminals unless the wiring has been
disconnected at the network interface.
• Use caution when installing or modifying communications wiring or components.
• SAVE THESE INSTRUCTIONS.
Mounting the 58A00-1
Once you have determined the proper location, the 58A00-1 can be
permanently mounted.
NOTE:
It is the responsibility of the installer to ensure that the 58A00-1 is
securely mounted in the intended location.
Using Provided Screws:
Remove the back from the transmitter (Figure A). Mount the back housing of
the 58A00-1, using the screws supplied, to the desired location.
The 58A00-1 Mini Door/Window Transmitter is a mini sized supervised wireless
contact that works with the Leviton 45A00-1 Wireless Receiver.
Powering the 58A00-1
For your added convenience, the 58A00-1 comes with the battery preinstalled.
To activate, hold the 58A00-1 firmly in one hand and pull the plastic tab in the
direction indicated.
Locate Transmitter
Select the location where the 58A00-1 is to be mounted.
NOTE:
RF signals can be affected by metal objects, including metal doors
or large mirrors. Such locations should be avoided as they can interfere with
proper operation.
Enrolling the 58A00-1
To enroll the 58A00-1, put the 45A00-1 Wireless Receiver in to Setup mode
and advance to an unused address location. Activate the reed switch by
removing the magnet from the transmitter for 1 second, then replacing it. Refer
to the Installation Instructions for the 45A00-1 for additional information.
Using Adhesive Tape:
Ensure that the surface is clean and dry. Apply the supplied tape to the back
of the 58A00-1, press and hold firmly in the desired location for approximately
10-15 seconds. It can take up to 24 hours for the tape to reach maximum
bonding strength.
Align the magnet with the notched arrow
on the 58A00-1 housing.
Mount the magnet a maximum of .4” (1. 8cm) from the 58A00-1 by using the
provided tape or screws. If necessary use the spacers provided. Once the
58A00-1 and magnet are mounted, open and close the window/ door to ensure
that none of the parts interfere with this movement. Only one magnet can be
used for each 58A00-1.
WEB
VERSION