KVH Industries TracVision M9, Replacement Instructions Manual

Page: 1 / 7

KVH, TracVision, and the unique light-colored dome with contrasting baseplate are registered trademarks of KVH Industries, Inc.
All other trademarks are property of their respective companies. The information in this document is subject to change without notice.
No company shall be liable for errors contained herein. © 2008 KVH Industries, Inc., All rights reserved. 54-0534 Rev. A
1
These instructions explain how to replace the skew motor or skew motor belt in a TracVision
M9 antenna.
Installation Steps
Tools Required
This procedure requires the following tools:
Technical Support
If you need technical assistance, please contact KVH Technical Support:
Skew Motor Replacement Instructions
1. Remove the Radome, 2
2. Remove the Feed Tube and Reflector
Bracket, 2
3. Measure the Current Belt Tension, 3
4. Replace the Motor, 3
5. Set the Belt Tension, 3
6. Reinstall the Reflector Bracket and Feed
Tube, 4
Skew Motor Belt Replacement Instructions
1. Remove the Radome, 5
2. Remove the Feed Tube and Reflector
Bracket, 5
3. Replace the Belt, 6
4. Set the Belt Tension, 6
5. Reinstall the Reflector Bracket and Feed
Tube, 6
• Phillips screwdrivers
• 5/64" Allen key
• 3/32" Allen key
• Tension meter
• 7/16" open-end wrench
N. America, S. America, Australia:
Phone: +1 401 847-3327
E-mail: techs@kvh.com
Europe, Middle East, Asia:
Phone: +45 45 160 180
E-mail: support@kvh.dk
Skew Motor/Belt Replacement Instructions
for TracVision
®
M9