85376 / 85476 /85576
Contents
RC Vehicle (Vehicle) x 1
RC Transmitter (Transmitter) x 1
Antenna for RC Transmitter x 1
Instruction Manual x 1
Battery Requirement
1. Vehicle: 5 x 1.5V “AA” batteries
2. Transmitter: 1 x 9V battery
5 x AA
For Vehicle
( Not Included )
1 x 9V
For Transmitter
( Not Included )
Battery Precaution
1. Alkaline batteries are recommended to be used
2. Only batteries of the same or equivalent type as recommended are to be used
3. Do not mix alkaline, standard or rechargeable batteries
4. Do not mix old and new batteries or different type of batteries
5. Non-rechargeable batteries are not to be charged
6. If rechargeable batteries are to be used, they are only to be charged under adult supervision
7. Rechargeable batteries are to be removed from the product before they are charged
8. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions
9. Remove all batteries from the Vehicle and Transmitter when not in use
10. Exhausted batteries are to be removed from the product
11. The supply terminals are not to be short-circuited
12. Dispose of batteries properly. Do not dispose the batteries in fire - it may cause them to explode or leak causing injury or damage
13. Battery installation and removal must only be done by adult
Battery and Antenna Installation
For Vehicle (Fig. 1 and Fig. 2)
1. Switch OFF the power
2. Unscrew the screw and lock on the battery cover
3. Push the battery cover downward
4. Open the battery cover
5. Install 5 new 1.5V “AA” batteries with correct polarities (+/-)
as shown inside the battery compartment
6. Close the battery cover
7. Push the battery cover upward to lock it
8. Tighten the screwn and lock on the battery cover
Vehicle
Vehicle - Battery Cover
Vehicle - Battery Installation
Vehicle - Battery Cover
Direction
Adjustment
Battery
Compartment
ON / OFF Switch
Transmitter
Transmitter -
Battery Installation
Forward /
Backward
Transmitter
Antenna
LEDBattery
Indicator
Left/
Right
OFF / ON
For Transmitter (Fig. 3 and Fig. 4)
1. Switch OFF the power
2. Unscrew the screw on the battery cover
3. Open the battery cover
4. Install 1 new 9V battery with correct polarities (+/-)
as shown inside the battery compartment
5. Close the battery cover
6. Tighten the screw on the battery cover
7. Insert the antenna into the top of Transmitter, tighten it by rotating
clockwise (viewing from top of Transmitter)
9
9
-1
5
1
2
1
1
-4
8
6
2
1
