ISO PREFERRED, 1419 DONELSON PIKE, SUITE A, NASHVILLE, TN 37217
ISOPREFERRED.COM
jljlkjljljlk
ISO Preferred Lumbar Back Brace IV (BA204) has a heat moldable posterior panel. It is intended to provide support for the L1 to L5
vertebra for conditions such as mild disc herniation of the lumbar, strain or sprain of the lower back, Spondylosis, Spondylolisthesis
and Lumbago.
Lumbar Back Brace IV
The
ISO Preferred Lumbar Back Brace IV
reduces the time it takes to heal discomfort from
injuries or post-surgery. Please follow your orthopedic professional’s instructions explicitly
and adjust or discontinue use only as directed to achieve maximum benefit for your
concerns.
Always Putting Our Patients First
1
. The belt is designed to fit waist sizes Small to 2XL. To apply, lay out the back brace on a
flat surface. Ensure the pull tabs are nearest to the middle of the back of the brace without
the cords bunching up.
2. Position the center of the lumbar back brace over your spinal region at your desired
height. Pull firmly and equally on both sides of the support belt, wrapping and overlapping
them in front of your stomach. Then secure together with fastening fabric.
If the belt is too long or too short, turn belt to inside, unfasten the belt overlap at
position “A” and adjust the length on each side. Adjust both belts equally to position
front and back plates properly. Excess belt may be cut as desired.
Proceed to apply and fasten the belt as instructed above.
3. Detach both pull tabs (attached to the cords) from the support belt. While pulling slowly
towards the front of your stomach, firmly and evenly increase the compression support
to your doctor’s prescribed specific level. Re-attach both pull tabs.
DO NOT
OVERTIGHTEN
.
ISO Lumbar Belt Extension: Universal (Optional- BA202)
For additional length at the waist securely fasten the (optional
) ISO Lumbar Belt
Extension: Universal
to each side of the ISO Lumbar Belt.
3
2
2
1
A
A
