Installation Instructions
Family: Atlantis | Item No. 55602
Start Here
HINKLEY
33000 Pin Oak Parkway
Avon Lake, OH 44012
(p)800.442.5539 / (f) 440.653.5555
www.hinkley.com
Top Cover
Glass
Quick Connect
Ground wire
Condui
Conduitt
connection
Bollard Mount
PVC
Set Screw
Concrete
(optional)
2 1/2"
Min Hight
4 1/2"
Max
Threaded Tube
Note: Threaded
tube can be
adjusted to
change hight of
fixture
Bottom Plate
Wiring Coupler
Bottom Cover
E
xternal tooth
washer (lock)
PVC
Please do not
cut the top of
the PVC pipe
UBM to rest on top of
Pipe.
E
xternal tooth
washer (lock)
Nut
Unpacking
1. Unpack the bollard and the glass from the box.
2. Remove the bollard mount, threaded tube assembly, and PVC pipe from the box.
Luminaire Mounting
Note: If your local code requires a frost line burial deeper than 12 inches, you may
purchase a 2 inch PVC pipe (sch. 40 or sch. 80) from a local supplier and cut to
length as a replacement to the provided PVC pipe.
1.
Dig a hole about 12 inches or deeper, depending on your
local code.
2.
Feed the wires through the PVC pipe and insert it in the
ground, make sure the PVC is sticking out of the ground
enough that the bollard mount will fit on top of the PVC, and
that the bottom of the bollard mount is level with the ground.
3.
Fill in the hole around the PVC pipe.
4.
Level the PVC pipe with a post level.
5.
Feed the wires through the bollard mount and the threaded
tube assembly, pull the wires out through the wiring coupler.
6.
Put the bollard mount on top of the PVC pipe.
7.
Tighten the three set screws on the sides of the bollard
mount.
Assembly
1.
Wire the fixture wires and the main wires together using wire
nuts. Put the silicone glue, that’s provided, in the wirenuts to
waterproof. All connections must be housed with in the lower
section of the bollard and above ground.
2.
Remove the bottom cover.
3.
For ground installation: screw the nut
s
(supplied) onto the
threaded tube to get the correct height adjustment. This step
is
not needed for concrete or other hard surface installations.
4.
Put the main body of the fixture over the bollard mount and
threaded tube assembly.
5.
Rotate the fixture to the desired position.
6.
Put a nut
and two external tooth washers
(supplied in the
parts bag) on top of the threaded
tube and tighten.
7.
Replace the bottom cover.
8.
Unscrew the four screws from the top cover and remove the
cover.
9.
Insert the glass into the fixture, and screw it in
.
10.
I
nsert the LED into the top cover, screw in the set screw
to secure to the top
and
connect the wires with the quick
connect.
11.
Put the top cover back on and tighten the four screws
