1
Phone: (866) 205-‐5268 Fax: (813) 247-‐6200
Email: [email protected]
4951 E. Adamo Dr. Ste. 238, Tampa, FL 33605
Xbox One Rapid Fire X-‐3
Congratulations on your new Rapid Fire Controller! Please read through instructions before programming
your controller so you know what to do.
The GamerModz – SPS-‐X3® – allows the user to toggle between No Rapid Fire, Single Trigger Rapid Fire, or Dual Trigger
Rapid Fire. Additionally, this mod allows the user to pre-‐set program 5 different modes. The user has complete control
over how many shots per second they wish to fire at. This mod is 100% undetectable and fully adjustable.
Programming the Controller:
***You must sync and connect your controller to your Xbox One Console before programming mods***
Please be aware that programming each mode is a 2-‐part process; First choosing either burst mode or fully automatic,
then setting the number of shots per second.
1.Choose one of the 5 available modes that you wish to program. To do this, press the sync button the number
of times that corresponds with the mode you want for example, to get to mode 3, press the sync button 3 times, and
then pull the right trigger briefly (0.5 seconds).
2.After selecting the mode you wish to program, pull and hold the right trigger and press down on the sync
button. When the main LED begins to flash, release both the sync button and right trigger. The main LED will flash 5
times, indicating that you’re in programming mode.
3.Once in programming mode, you must decide whether you want fully automatic or burst mode.
To Program for Fully Automatic:
Once in programming mode, pull the right trigger once, and then press the sync button. The main LED will flash
once. Your mode is set for fully automatic – proceed to step 4.
To Program for Burst Mode:
Once in programming mode, pull the right trigger the amount of rounds you want fired per burst (for example,
2 trigger pulls will be 2 round burst), and then press the sync button briefly (0.5 seconds). The main LED will flash and
your mode is set to burst mode– proceed to step 4.
4.Now that you’ve chosen fully automatic or burst mode, pull and release the right trigger the exact number of
times you would like to shoot per second. (For example: 11 pulls = 11 shots per second.)
5.Once you have pulled the trigger the amount of times you want it to fire per second, press the sync button
again briefly (0.5 seconds).
6.The main LED will flash the amount of times you pulled the trigger to confirm the rapid fire “shots per
second”. Your chosen mode is now programmed.
Assigning rapid-‐fire to a trigger:
1. The rapid-‐fire mod default to “right trigger only.”
2. To set the rapid-‐fire for “left trigger only,” hold in the left trigger and briefly press the sync button. The main LED will
flash 1 time, indicating that it has changed trigger modes.
3. To set the rapid-‐fire for “dual triggers,” hold down both triggers simultaneously and press the sync button. The main
LED will flash one time, indicating it has switched to “dual triggers.”
4. To return to the right trigger default, press the sync button and the main LED will flash once, confirming that you are
back in “right trigger only.”
