S2Tech 699PLUS, Instruction Manual

Page: 1 / 4

LoadSentry
Instruction Manual MANU
Digital load measuring system
S2Tech srl
Via Imperia, 28 Milano ITALY
Tel: +39 02 8910142 - Fax: + 39 02 89124848
e-mail: info@s2tech.it
www.s2tech.it
Version : UK 3r3 dated 05/05/17
Page: 4/6
699PLUS CONTROLLER CONNECTIONS
Screw Terminal Meaning
1 GND (DC POWER SUPPLY)
2
+ 24 V (DC POWER SUPPLY)
3 EARTH connection
4 CONTACT I/O 2 (Display Zeroing )
5 CONTACT I/O 1 (Chain compensation)
6 I/O CONTACT's common reference
7 Relay 3 - Normally Open contact
8 Relay 3 - Normally Closed contact
9 Relay 3 Common contact
10 Relay 2 - Normally Open contact
11 Relay 2 - Normally Closed contact
12 Relay 2 Common contact
13 Relay 1 - Normally Open contact
14 Relay 1 - Normally Closed contact
15 Relay 1 Common contact
16 + power supply to transducer
17
- power supply to transducer
18 + signal form transducer
19 - signal from transducer
23 AGND (Analog output)
24 Analog Output
Ground to earth the 699 electronics and respect all the relevant safety and electrical
regulations .
Once performed all the needed electrical connections feed power supply and wait 15
minutes, before calibrating.
Measurement changes are displayed in tens of the used
engineering units.
POWER SUPPLY = 24 Vdc
699PLUS CONTROLLER
QTY 1 699Plus weight controller
QTY 2 Fixing screws, type M4 x 12 UNI 7687
QTY 2 Nuts, type M4
PUSHBUTTONS AND THEIR ACTION for 699Plus programming
Use or to view available parameters.
Use
E
to view and modify existing numeric parameter or to confirm changes to parameter.
699Plus indicates that new parameter has been accepted by showing, briefly, MEMO and
Use
C
to:
abort changes to numeric parameter, maintaining the existing value
end calibration SAVE changed parameters - and start load measurement
To modify numeric parameters, use to increase or to decrease value of one unit.
+
E
increase value of 10 and then 100 units while
+
C
decreases of 10 and then 100
units.