READ ENTIRE INSTRUCTIONS
BEFORE INSTALLATION.
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
P R O D U C T D I M E N S I O N S
P R E - I N S T A L L A T I O N I N S T R U C T I O N S
Thank you for purchasing a quality stainless steel canopy rangehood. We have a high
standard of quality control and each rangehood is tested and approved before it leaves the factory.
Installation work and electrical wiring must be done by qualified person(s) in accordance with all
applicable codes and standards, including fire-rated construction. When cutting or drilling into wall or
ceiling, do not damage electrical wiring and other hidden utilities.
Use this unit only in the manner intended by the manufacturer. If you have any questions, contact
the manufacturer.
The canopy is heavy: overall weight 50.6 lbs (23kg). Please ensure adequate care when installing the
canopy to prevent personal injury. The canopy must be installed onto a solid wall or solid studs.
Designer Canopy
88507 HC36DXB1
35 1/3” (898mm)
12 ~ 1/2”
(317mm)
2 ~ 13/16”
(72mm)
10 ~ 7/8”
(276mm)
19 ~ 9/16”
(497mm)
min 23 ~ 5/8”
(600mm)
max 32 ~ 1/2”
(825mm)
20” (507mm)
400030_A
Electrical Rating:
120V 60Hz 285W 3,5A
This appliance is not intended for use by young children or infirm persons without supervision.
Young children should be supervised to ensure that they do not play with the appliance.
Upon installation the appliance must be positioned so that the plug is accessible.
There should be adequate ventilation of the room when the rangehood is used at the same time as
appliances burning gas or other fuels.
Yo u m u s t r e a d t h e d e ta i l s c o n c e r n i n g t h e m e t h o d a n d f r e q u e n c y o f c l e a n i n g .
There is a fire risk if cleaning is not carried out in accordance with the instructions.
Exhaust air must not be discharged into an existing flue used for exhausting fumes from appliances
burning gas or other fuels.
The recommended minimum distance between the hob surface and the lowest part of the rangehood
is 29.5” (750mm).
Attention should be given to ensure that any applicable regulations concerning the discharge of
exhaust air is fulfilled.
If the supply cord of this equipment is damaged, it must only be replaced by the manufacturer or
its service agent, or a similarly qualified person in order to avoid a hazard.
WARNING - TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
W A R N I N G S
CLEANING INSTRUCTIONS
Care and attention should always be taken when cooking with oils, alcohol, etc, which give off
flammable vapours. Pre-used oil is especially dangerous in this respect. Do not use an
uncovered electrical grill. Particular care must be taken with grease filters which must be
periodically cleaned, at least every two months. Remove the grease filters and wash them
either by hand or in the dishwasher using mild detergent. Use lukewarm water and mild
detergent to clean stainless steel components. In high humidity and coastal environments,
cleaning should be carried out frequently. CAUTION: Never use abrasive or oil based liquid cleaners.
O P E R A T I O N I N S T R U C T I O N S
CONTROL PANEL
Delay switch - Fan will remain on at low, mid or high speed for 5 minutes before switching off
automatically.
I
I I
I I I
Fan On/Off
Mid Speed
High Speed Delay Switch
Light On/Off
I
MANUFACTURED FOR
BY:
ROBINHOOD LIMITED
6 ZELANIAN DRIVE, EAST TAMAKI
AUCKLAND, NEW ZEALAND
Fisher & Paykel Appliances, Inc.
27 Hubble, Irvine, CA 92618
Toll Free 1-888-9-FNP-USA (1-888-9-367-872)
